Effect of Heat Treatment on the Structure and Properties of Titanium Alloy VT22 Welded Joints Produced by TIG-Welding with Flux-Cored Wire

Prilutsky, V.P.; Akhonin, S.V.; Schwab, S.L.; Petrychenko, I.K.

doi:10.4028/www.scientific.net/msf.927.119

Cited by 12 publications

(1 citation statement)

References 13 publications

Supporting

Mentioning

Contrasting

Unclassified

Order By: Relevance

“…Тим не менш, експериментально показано можливість виплавки сплавів з високим вмістом цирконію та ніобію. Такі сплави можна використовувати в якості лігатур та матеріалів для виробництва порошків, що може бути корисним в адитивних технологіях 3D-друку і наплавлення металопорошковим дротом [13].…”

Section: нові тметоди та прогресивні технології литтяunclassified

Technological features of obtaining alloys and master-alloys of TI-ZR-NB-SN system in the conditions of electron beam casting technology

Voron¹,

Schwab²,

Selin³

2022

Processy litʹâ

View full text Add to dashboard Cite

Electron beam casting technology is a unique method for obtaining cast products and semi-finished products from a wide range of titanium alloys. This technology can be very promissing in production of biocompatible titanium alloys for endoprosthesis. A particularly difficult and important task in this context is preparation of Ti-Zr-Nb-Sn system alloys with high strength and low modulus of elasticity. As a result of experimental development of specified alloys melt preparation technological modes, possibility of obtaining complex titanium alloys with a high content of zirconium and niobium was shown. It is also determined, that when the niobium content in the charge is more than 30 % wt. there is a decrease in the concentration of titanium and zirconium in the melt due to their freezing on the walls of the skull. As a result, there is a change in the chemical composition of the melt, the amount of niobium in which can exceed 50 % wt. Maximum amount of tin that can be assimilated in titanium-based melts under EBCT conditions is 5 % wt., and niobium-based melts are twice less. It has been proven that obtaining melts of Ti-Zr-Nb-Sn system with a precise chemical composition, using the chosen method, is a difficult and still unsolved problem, but due to the possibility of melting alloys with a high content of niobium and zirconium in its conditions, this method is effective in the production of master alloys and ingots for the production of powders used as raw materials for additive tmanufacturing. Keywords: titanium alloys for endoprosthesis, foundry production, Ti-Zr-Nb-Sn, electron-beam casting technology.

show abstract

Section: нові тметоди та прогресивні технології литтяunclassified