Effect of High-speed Milling tool path strategies on the surface roughness of Stavax ESR mold insert machining

Mebrahitom, A.; Rizuan, D.; Azmir, Mohd; Nassif, Mohamed

doi:10.1088/1757-899x/114/1/012006

Cited by 5 publications

(1 citation statement)

References 6 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Over the last few years, new strategies for highspeed roughing have been introduced that offer significant increases in metal removal rates and provide much shorter machining times [3][4][5][6][7]. In paper [8], six different tool path strategies have been investigated on the surface finish and machining time of a rectangular cavities of ESR Stavax material. Here, the authors noted that in order to effectively use the HSM capabilities, optimizing the tool path strategies and machining parameters is an important issue.…”

Section: Analysis Of Information Sourcesmentioning

confidence: 99%

Forecasting of the productivity of parts machining by high-speed milling with the method of half-overlap

et al. 2018

View full text Add to dashboard Cite

In the article the technology of high-speed milling was observed as a key to the most promising methods of engineering products machining. It is indicated that the correct choice of the strategy for moving the cutting tool in the manufacture of products is the basis for ensuring the desired surface quality of the workpiece and its high processing efficiency. A review of the work devoted to the diagnosis of high-speed processing strategies was performed. Based on the up-to-date knowledge of the physics of the process of establishing of a qualitative surface, the article proposes to consider a new technology of high-speed milling with half-overlap. As the main idea of this technology, it is suggested to consider the work of the deformation component of cutting process as the main component of the complex energy-intensive process of high-speed milling. In addition, the paper suggests a technique for estimating the productivity of machining by the method of high-speed milling with half-overlap. It is theoretically justified that the specific productivity of the proposed technology is quite high Q=12.5÷4.2 cm 2 /min and depends on the technological regimes. The place of technology of high-speed milling with half-overlap in the technological process of manufacturing details of any complexity was noted. The area of further research is indicated.

show abstract