Effect of hot-pressing temperature on microstructure and the improvement of residual Al on tensile ductility of Ti/Al3Ti heterogeneous structure

Miao, Yuzhong; Yuan, Meini; Fan, Zhiqiang; Wang, Xidong; Li, Zhaocan; Zhou, Xiaosheng; Wang, Honglin

doi:10.1016/j.msea.2022.144291

Cited by 13 publications

(1 citation statement)

References 60 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Miao et al [26] investigated Ti/Al 3 Ti HS materials with different residual Al contents and found that the elongation of Ti/Al 3 Ti/Al was 64.2~228.5% higher than that of Ti/Al3Ti. Fan et al [27] produced TiC/(TC18 + TC4) composites with HS materials.…”

Section: Introductionmentioning

confidence: 99%

Influence of Interface Type on Dynamic Deformation Behavior of 3D-Printed Heterogeneous Titanium Alloy Materials

Li,

Luo,

Wang

et al. 2024

Materials

View full text Add to dashboard Cite

Using the Split Hopkinson Pressure Bar technique, strain-limited dynamic compressive loading experiments were performed on TA1/TA15 heterostructure (HS) materials. The plastic deformation mechanisms, fracture forms, and energy absorption properties of an HS material with a metallurgical bonding interface (MB) and an HS material without a metallurgical bonding interface (NMB) are compared and analyzed. The results show that there is no significant difference between the two deformation mechanisms. The fracture forms are all “V-shaped” fractures within the TA1 part. The NMB was carried for 57 μs before failure and absorbed 441 J/cm3 of energy. The MB was carried for 72 μs before failure and absorbed 495 J/cm3 of energy. Microstructure observations show that there is a coordinated deformation effect near the MB interface compared to the NMB, with both TA1 and TA15 near the interface carrying stresses. This causes an enhancement of the MB load-bearing time and a 12% increase in energy absorption.

show abstract

Section: Introductionmentioning

confidence: 99%