aPrehydrolysates and water-insoluble solids (WISs) were produced from reed straw and corn stover pretreated with hydrolysate-recycled liquid hot water (LHW) at different cycle times. The chemical components of the prehydrolysates and WISs were then investigated to assess the possible effects of hydrolysate recycling on bioethanol production. The WISs were subjected to fed-batch, semi-simultaneous saccharification and fermentation (S-SSF) to investigate the changes in bioethanol concentration and evaluate the efficiency of the pretreatment. The pretreatment conditions consisted of a temperature of 195 °C, time of 20 min, and liquid ratio of 1:20. The prehydrolysates were recycled using a circulation volume of 50% and were applied to 10 cycles. The results showed that recycling did not significantly decrease the pH of the hydrolysates. The content of glucose and xylan in the hydrolysates decreased and then increased with increasing cycle times. In the WISs, the contents of benzene alcohol extractives and ash increased remarkably. The content of acid-insoluble lignin and glucan increased slightly. The amounts of xylan and acid-soluble lignin in the WISs were low, and the changes in these contents were not significant. Thus, hydrolysate-recycled LHW pretreatment was beneficial for bioethanol production from reed straw, but not from corn stover. : Bioethanol; Liquid hot water pretreatment; Hydrolysate-recycled; Reed straw; Corn stover Contact information: a: Dalian Polytechnic University, Dalian 116034, P. R. China; b: State Key Laboratory of Pulp and Paper Engineering, South China University of Technology, Guangzhou 510640, P. R. China; * Corresponding authors: yangrf@dlpu.edu.cn; lujie@dlpu.edu.cn
Keywords
INTRODUCTIONBioethanol is primarily produced from starch materials. However, the limited availability and relatively high price impede large-scale production of bioethanol from starch materials (Bai et al. 2007). As the largest source of sugar for fermentation, lignocellulosic biomass is a promising raw material for bioethanol production (Guerriero et al. 2016). Therefore, the conversion of lignocellulosic biomass into bioethanol should be investigated for the potential to develop new energy resources (Oberoi et al. 2011). Converting lignocellulosic biomass into bioethanol generally involves three steps: pretreatment, enzymatic hydrolysis, and fermentation. Pretreatment is necessary to convert lignocellulosic biomass into bioethanol with high efficiency (Dionisi et al. 2015). Therefore, various methods have been developed to improve biomass fractionation through pretreatment substances and processes, such as dilute acid (Hsu et al. 2010), alkaline Liquid hot water pretreatment has been recognized as an environmentally friendly technology. A previous study investigated the important characteristics of reed straw and corn stover that determine successful LHW pretreatment. The results revealed that LHW could remove up to 80% of hemicelluloses and enhance enzymatic digestibility (Lu et al. 2012). A large amou...