Effect of Nanosilica Incorporation on Flexural Strength, Shear Bond Strength, and Color of Veneering Porcelain after Thermocycling

Abstract

AIM: The focus of this research was to see how silica nanoparticles changed veneering porcelain over a zirconia core affected flexure strength, shear bond strength, and color. METHODS: A total number of 30 zirconia core veneer samples were constructed and classified according to silica nanoparticles modification of veneering porcelain into two groups: Group 1 (control group) veneering porcelain without any modification (n = 15) and Group 2 (modified group) veneering porcelain modified by silica nanoparticles (n = 15). Silica nanoparticles were added to the veneering porcelain powder at a rate of 5% by weight. Silica nanoparticles powder and veneering porcelain powder were manually crushed for about 10 min using a pestle and mortar then the mixed powder was combined with the porcelain moldings liquid to make a paste. After thermal cycling, each group was examined for flexural strength, shear bond strength, and color measurement (n = 5). Universal testing equipment was used to determine flexural and shear bond strength. The color shift was measured using a spectrophotometer. RESULTS: Flexural strength levels in the modified group (280.9 ± 29.85 Mpa) were substantially higher than in the control group (431.78 ± 22.73 Mpa). Shear bond strength values in the modified group (34.31 ± 5.6) were significantly higher than in the control group (26.97 ± 4.03). Color change was within the clinical acceptable range (1.71 ± 0.32). CONCLUSIONS: The addition of silica nanoparticles to veneering porcelain improved the flexural and shear bond strength, as well as, color change was within the clinical acceptable limits.

Flexural strength OF MILLED PEEK BAR VERSUS PEKK BAR ON TOOTH SUPPORTED OVERDENTURES. IN VITRO STUDY

“…Yield is when you have pushed a material beyond its recoverable deformation, and it will no longer go back to their shape again. 16 Measuring can be done using either 3 points or 4 points bending test. The main difference between both bending tests is the area in which the maximum bend stress occurs.…”