Effect of Soil Degree of Saturation on Pile Load Capacity at Different Slenderness Ratios

Abstract

The conventional methods follow in designing piles adopt the assumption of saturated condition of soil depending on soil parameters at saturated condition while at most cases the whole piles or part of them lays in unsaturated soil zone, thus the estimated pile capacity will be far of the real. This issue made the need to study the pile capacity at unsaturated condition and compare it with saturated condition. This study is performed to investigate the behavior of single pile inserted in clay soil at different degrees of saturation. The test was performed under axial compression loads by using different degrees of saturation (100,80,60,40%). A pile of 14x14 mm cross section with different slenderness ratios (L/D) (24,30,36) employed in the study. The impact of saturation degree, matric suction and slenderness ratio on pile load capacity is examined. The results illustrate that pile capacity influenced considerably by the saturation degree, matric suction, and slenderness ratio. The results showed that when saturation degree reduced from 100% to (80,60,40%), bearing capacity of pile increased for all L/D used. An example ultimate capacity of pile with L/D (24) increased (380, 512, 63%) by de-creasing degree of saturation from 100 % to(80 ,60 ,40%) respectively, this means the pile capacity increased about four times by decreasing Sr. from 100 % to 80 % , five times by decrease Sr. from 100% to 60 % and little increase (63 %) in pile capacity by decreasing Sr. to 40 %.A close results had been observed at L/D 30 and 36. The effect of increasing slenderness ratio had been studied at different saturation degrees, an ex-ample by increasing L/D from 24 to 30 pile capacity increased (11.45, 10.2, 25, 32.5%) at Sr.(100 ,80 ,60 ,40%) respectively.