1998
DOI: 10.1049/ip-gtd:19982361
|View full text |Cite
|
Sign up to set email alerts
|

Effect of surface charge on hydrophobicity levels of insulating materials

Help me understand this report

Search citation statements

Order By: Relevance

Paper Sections

Select...
2
1
1
1

Citation Types

0
9
0
1

Year Published

2001
2001
2021
2021

Publication Types

Select...
7
1

Relationship

0
8

Authors

Journals

citations
Cited by 34 publications
(10 citation statements)
references
References 13 publications
0
9
0
1
Order By: Relevance
“…If the charged particles deviate from the appropriate range of the q/m values, for most of the particles to move with the same driving voltage, the charged particles will show an irregular movement because of the obstruction of their movement. Moreover, the electrical and optical properties of the panel must be degraded with a short lifetime [7,8].…”
Section: Resultsmentioning
confidence: 99%
See 2 more Smart Citations
“…If the charged particles deviate from the appropriate range of the q/m values, for most of the particles to move with the same driving voltage, the charged particles will show an irregular movement because of the obstruction of their movement. Moreover, the electrical and optical properties of the panel must be degraded with a short lifetime [7,8].…”
Section: Resultsmentioning
confidence: 99%
“…When the positively and negatively charged particles are in the same cell without any bias voltage, the charged particles exert a Coulomb force (i.e., attractive and repulsive force) and an image force is associated with the charged particles and the conductive electrodes. These forces are in proportion with the value of q/m, where q is the amount of the electric charge of a particle, and m is the mass of the particle [7,8]. Therefore, a force greater than the abovementioned forces is required to move the charged particles.…”
Section: Introductionmentioning
confidence: 99%
See 1 more Smart Citation
“…In another particle-insertion method, namely the corona-gun method, charged particles are accelerated by the high voltage bias of over 200 V at the electrode of a corona gun, and are piled on the lower substrate [11]. This method, in common with the simple particle-loading method, cannot filter the non-moving particles; and, additionally, results in an increase in electric and mechanical damage of particles during the particle-insertion process [12].…”
Section: Particle-moving Methodsmentioning
confidence: 99%
“…One electrode is connected to the high voltage source through a resistance of 10 MΩ and the other electrode connected to ground. Figure 2 shows the experimental setup used to measure the surface charge accumulation on OIP material [27]. The sample was charged by non-contact corona discharge using needle plane electrode configuration at position 1.…”
Section: B Test Electrodementioning
confidence: 99%