Effect of thermomechanical parameters on dynamically recrystallized grain size of AZ91 magnesium alloy

Dynamic recrystallization behavior of an as-cast TiAl alloy during hot compression

“…Before the flow stress reaches to the steady state during the hot compression, the grain size is found to be inversely proportional to the Zener-Hollomon parameter [19], as shown in Fig. 5, and can be approximated on grounds of the experimental data as:…”

Annealing behaviour of Mg–3Al–1Zn alloy sheet obtained by a combination of high-temperature rolling and subsequent warm rolling

“…investigation of the influence of thermomechanical parameters on the DRX grain size [1] and elucidation of the DRX mechanism [2], owing to the fact that DRX leads to grain refinement during deformation and, in turn, to enhancements of hot workability and mechanical properties. In contrast, little work has been done on static recrystallization (SRX) during annealing after deformation especially on the texture evolution and elucidation of the mechanism of SRX in wrought Mg alloys.…”

Hot deformation behavior of as-cast Mg–Zn–Mn–Ce alloy in compression

“…6(b)). The fine precipitates contribute to the pinning of the recrystallized grain boundaries and therefore restrict their growth, leading to reduction of recrystallized grain size [29]. It was also reported that a high precipitate density was found to reduce twinning activity [30,31].…”