Effect of topology on the performance of PV module

Kumar, Sandeep; Kakkar, Sushma; Iqbal, Asif

doi:10.1109/icccnt.2017.8204046

Cited by 3 publications

(3 citation statements)

References 9 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…A DC wound motor can be modeled in Simulink. The equation used to represent the mechanical part implementation is shown in equation (2).…”

Section: Motormentioning

confidence: 99%

“…Further, the operation of the motor is governed by equations ( 3) -( 4) Where, T e and T L > 0 The electrical torque output depends upon the magnitude of the armature current. The rotor speed can be calculated from equation (2). Mechanical and electrical torque should be greater than zero to operate DC machines in the motoring region.…”

Section: Motormentioning

confidence: 99%

“…Kumar et al (2) investigated the variation in operating points in numerous PV seriesparallel arrangements. Hong et al (3) studied the PV system for rooftops under partial shading conditions.…”

Section: Introductionmentioning

confidence: 99%

See 2 more Smart Citations

DC Motor Load performance in DC system with reconfiguration of PV Array

Soni¹,

Fernandez²

2021

IJST

View full text Add to dashboard Cite

Objectives: To examine if the changing of the series-parallel configuration of photovoltaic (PV) array can influence a simple DC drive performance. Methods: In this study, a simulated investigation is carried out for a PV system consisting of 30 panels arranged in 3*5 and 5*3, 3*6 and 6*3, 5*6, and 6*5 configuration. Two motors of rating 5 HP and 10 HP are used for the simulation. The first category includes the mentioned configuration in which the number of series PV panels (N s ) is higher than the number of the parallel panel (N p ) such as 5*3, 6*3, and 6*5. The second category includes the combination in which the number of PV panels connected in parallel is higher, such as 3*5, 3*6, and 5*6. Findings: The performance of the 5HP motor gets increased by 173.36%, and the performance of the 10 HP motor gets risen by 121.26% in 18 PV panel system when N s is higher than N p . Also, the system's overall efficiency gets improved when N s is higher than N p . Novelty: Usually, to vary the performance of the DC motor, power electronics circuitry is implemented. However, the performed simulated result shows that certain configurations will give better performance. Therefore, control for the DC motor's enhanced performance can be accomplished without the power electronics control system.

show abstract

“…A DC wound motor can be modeled in Simulink. The equation used to represent the mechanical part implementation is shown in equation (2).…”

Section: Motormentioning

confidence: 99%

Section: Motormentioning

confidence: 99%