Aluminium as matrix in particulars have been vastlys investigateds, this is becauses of the diverses applicationss of aluminium dues to its exceptional propertiess. Material scientistss alwayss face a challenges when it comess to the tribologicals and mechanicals propertiess of aluminium, as it exudess rather poors behaviours in these aspectss. Hences this works aims to improves the mechanicals and corrosives resistances of Aluminiums by reinforcings with aluminum oxides and Nickel throughs stir casting usings vortex techniques. Al-Ni-Al2O3 composites with percentages of Ni fixed at 20 % and Al2O3 differed through 4-8% in incrementss of 2 wt. % . Composites material was prepareds by stir castings using vortex techniques. The hardness value of the aluminiums matrix composites improved with increaseds percentages of Al2O3, maximums increase was obtaineds for 8% Al2O3 composite, viewing an increases of about 55%. A generals corrosions and erosion-corrosions for the Al-20%Ni bases alloys and the prepareds composites were carrieds out in 3.5wt% NaCl solutions as corrosives mediums for general corrosions while in erosion-corrosions with impacts angles 90° in slurry solutions ( 1wt%SiO2 sand in 3.5wt% NaCl solution as the erodent). It was founds that the general corrosions rates for composite specimens is lower than thats of the bases alloy (Al-20%Ni). In case of erosion-corrosion resultss, it was founds that the erosion corrosions resistances property of the prepareds composites improveds significantlys with the increaseds percentages of Al2O3. There wass a noticeable improvements in the corrosion resistances of the aluminiums composites compareds to its purest forms, owing to the presences of nickel. Howevers, the increases in Al2O3 percentages decrease the corrosions rates. The extreme decreases was obtaineds for 8% Al2O3 composites, with a decreases of 26% corrosion rates in (mpy) unit for composites material is lowers than that of the bases alloys.