This instrument combines the capabilities of ion/ion reactions with ion mobility (IM) and time-of-flight (TOF) measurements for conformation studies and top-down analysis of large biomolecules. Ubiquitin ions from either of two electrospray ionization (ESI) sources are stored in a three dimensional (3D) ion trap (IT) and reacted with negative ions from atmospheric sampling glow discharge ionization (ASGDI). The proton transfer reaction products are then separated by IM and analyzed via a TOF mass analyzer. In this way, ubiquitin ϩ7 ions are converted to lower charge states down to ϩ1; the ions in lower charge states tend to be in compact conformations with cross sections down to ϳ880 Å 2 . The duration and magnitude of the ion ejection pulse on the IT exit and the entrance voltage on the IM drift tube can affect the measured distribution of conformers for ubiquitin ϩ7 and ϩ6. Alternatively, protein ions are fragmented by collision-induced dissociation (CID) in the IT, followed by ion/ion reactions to reduce the charge states of the CID product ions, thus simplifying assignment of charge states and fragments using the mobility-resolved tandem mass spectrum. Instrument characteristics and the use of a new ion trap controller and software modifications to control the entire instrument are described. Ion mobility (IM) [4,5] has become a very useful technique for analysis of biological ions in the gas phase [6]. IM provides information about ion size and structure [7], as it rapidly separates ions based on collision cross-section, rather than just m/z ratio. The use of IM to disperse a mixture of ions in time before analysis via a time-of-flight (TOF) MS, i.e., nested drift (flight) time measurements, is an important recent advance. These experiments were pioneered by Clemmer and coworkers in the mid-1990s [8], and have now been used by several other groups [9 -13]. The recent Synapt ESI-IMS-MS by Waters Corp. provides a commercially available instrument for gas-phase ion conformation studies by IM using a novel traveling wave approach [9].In a series of instrumental designs, the Clemmer group has made various modifications to the initial ESI-IM-TOF, including the insertion of a collision cell between the IM drift tube and the TOF for mobility labeling experiments [14,15], and the addition of an IT before the mobility drift tube to improve the duty cycle from the continuous ESI source [16,17]. One publication demonstrated MS/MS capabilities with an ion trap before IM-TOF [18], but the entire instrument was not under computer control. Therefore, only relatively simple experiments were possible.IM has been used to analyze the products of ionmolecule reactions [19], including proton transfer [20,21], H/D exchange [22], and solvation [23][24][25][26]. In these studies, the desired reactions take place either in the atmospheric pressure ion source interface region or in the drift tube itself. Thus, only short reaction times and certain reagent ions can be used. In addition, performing reactions in the IM cell can make spe...