Effects of Lubricating Conditions on Wear Performance of U77MnCrH Rail

Abstract

With the rapid development of railway towards being high speed and having heavy load capacity, the wheel–rail wear and rolling contact fatigue in the curve section with a small radius of freight have become the key problems in urban railways, which need to be solved urgently. The aims of this study were to compare the wear resistance with three different lubricating conditions on wheel–rail wear based on the wheel–rail rolling contact simulation tests. The wear loss, microhardness, and microstructure of the contacted surface of the rail were detected systematically. The results showed that the wear rates of rail were reduced by 71% for grease lubrication and 55% for solid lubrication, compared to those without lubrication. At the same time, the thickness of plastic deformation layer of rail samples were about 167 μm for the dry state, 138 μm for the solid lubrication state, and 128 μm for the oil lubrication state, respectively. It indicates that the thickness of the plastic deformation layer was significantly reduced under both grease and/or solid lubricating conditions. In addition, the microstructure of the deformation layer with two kinds of lubricated states was coarser and denser than that without lubricants. The average grain size of the deformation layer was approximately 0.22 μm under dry conditions and 0.32 μm under lubricated conditions. It also indicated that the changes in lubricants did not have a significant effect on the average grain size of the deformation layer. The results of the present study could provide theoretical reference for the development and design of lubricants used as rail materials.