Efficient removal of hydrogen sulfide from wastewater using waste-tire-derived rubber particles

Irfan, Muhammad; Siddiqui, M.; Bashir, Farzana; Butt, Muhammad Tahir; Abbas, Nadeem

doi:10.1007/s13762-020-02724-x

Cited by 12 publications

(3 citation statements)

References 32 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The process for measuring ash content was carried out following ASTM E 830-87 (Irfan et al, 2020). The remaining samples that had been heated to 575 ± 25 °C were reheated in the furnace for 7 minutes at a temperature of 950 °C.…”

Section: Ash Content Measurementmentioning

confidence: 99%

Analysis of Potential RDF Resources from MSW Landfills in Major Cities of Indonesia

Susilo

Hartono

Kusuma³

et al. 2022

J. Presipitasi

View full text Add to dashboard Cite

Many Indonesian landfills include the waste that has the potential to be used as an alternative fuel in the cement industry. It is converted into RDF to enable cement manufacturers to use waste. The research was conducted to know the Municipal Solid Waste (MSW) potential of 3 landfills (Bantargebang, Sumur Batu, and Cipayung) as a renewable fuel. Before processing, MSW is characterised because there are quality standards that the waste must meet before being used as fuel. That is a quantitative study combining a literature review and laboratory test methods. The parameters that have been measured from the three sample sites were water content, ash content, volatile level, and calorific value. The results showed that the total energy value acquired from Refuse Derived Fuel (RDF) resources of Bantargebang, Sumur Batu, and Cipayung landfills was 2742.14, 2741.24, and 2671.32 kcal/kg, respectively. In addition, based on the water content at the three sample locations, only rubber samples qualified for RDF processing. In contrast, rubber was the sole component that did not match the processing conditions to become RDF based on ash content. Furthermore, the volatile level of the three research sites meets the RDF standard.

show abstract

Section: Ash Content Measurementmentioning

confidence: 99%

Analysis of Potential RDF Resources from MSW Landfills in Major Cities of Indonesia

Susilo

Hartono

Kusuma³

et al. 2022

J. Presipitasi

View full text Add to dashboard Cite

show abstract

“…However, whereas most studies have investigated the removal of hydrogen sulfide gas, only a handful have focused on the removal of liquid‐phase hydrogen sulfide. In order to remove hydrogen sulfide from water and sediments, adsorbents prepared from coconut shell, palm kernel shell, wood sawdust (Habeeb, Kanthasamy, et al, 2020), waste‐tire‐derived rubber particles (Irfan et al, 2020), δ‐MnO 2 /porous graphitic carbon (Edathil et al, 2021), and calcined oyster shells (Yamamoto et al, 2022) have been proposed. We previously found that hydrogen sulfide in water can be removed from both fresh water and seawater using granulated coal ash (GCA) prepared from coal fly ash obtained from a coal electric power plant and blast furnace cement (Asaoka et al, 2012, 2017).…”

Section: Introductionmentioning

confidence: 99%

Effect of chemical composition of coal ash used to prepare granulated coal ash on the removal of hydrogen sulfide from water

Asaoka

Ishidu

Nakamoto

2023

Water Environment Research

View full text Add to dashboard Cite

Granulated coal ash was prepared by mixing coal ash derived from a coal electric power plant and blast furnace cement, to remove hydrogen sulfide from aquatic environment. In this study, we investigate the effects of the composition of the coal ash used to prepare the granulated coal ash on its hydrogen sulfide removal performance. Manganese, magnesium, and calcium contents in the granulated coal ash were found to be the major factors in controlling the rate of hydrogen sulfide removal. The kinetics of hydrogen sulfide removal by the granulated coal ash were expressed as a first‐order equation with a rate constant of 0.0081– 0.080 h‐1. The rate constant for hydrogen sulfide removal obtained in this study corelated well with the manganese content in the granulated coal ash. The increasing surface pH attributed to the hydrolysis of calcium and magnesium on the surface of the granulated coal ash slightly increased the hydrogen sulfide removal rate.

show abstract

“…Hence, rubbers have not been recycled owing to practical difficulties, such as separating rubbers from WTs and breaking the cross-linking of rubbers for reforming by further processing. [17][18][19][20] An interesting feature of WTs is the presence of metal particles such as Mn, Fe, Co, Ni, and Zn, although their origin is unknown. They can be incorporated into tires as agents for vulcanizing rubber.…”

mentioning

confidence: 99%

Upcycling waste tires to affordable catalysts for the oxygen reduction reaction

Lee

Kang

Jang

et al. 2021

Intl J of Energy Research

View full text Add to dashboard Cite

Efficient removal of hydrogen sulfide from wastewater using waste-tire-derived rubber particles

Cited by 12 publications

References 32 publications

Analysis of Potential RDF Resources from MSW Landfills in Major Cities of Indonesia

Analysis of Potential RDF Resources from MSW Landfills in Major Cities of Indonesia

Effect of chemical composition of coal ash used to prepare granulated coal ash on the removal of hydrogen sulfide from water

Upcycling waste tires to affordable catalysts for the oxygen reduction reaction

Contact Info

Product

Resources

About