Element activation method and non-conformal dynamic remeshing strategy to model additive manufacturing

Abstract

Modeling of Additive Manufacturing (AM) at the part scale involves non-linear thermo-mechanical simulations. Such a process also imposes a very fine discretization and requires altering the geometry of the models during the simulations to model the addition of matter, which is a computational challenge by itself. The first focus of this work is the addition of an additive manufacturing module in the fully implicit in-house Finite Element code Metafor [1] which is developed at the University of Liège. The implemented method to activate elements and to activate and deactivate boundary conditions during a simulation is adapted from the element deletion algorithm implemented in Metafor in the scope of crack propagation [2]. This algorithm is modified to allow the activation of elements based on a user-specified criterion (e.g. geometrical criterion, thermal criterion, etc.). The second objective of this work is to improve the efficiency of the AM simulations, in particular by using a dynamic remeshing strategy to reduce the computational cost of the simulations. This remeshing is done using non-conformal meshes, where hanging nodes are handled via the use of Lagrange multiplier constraints. The mesh data transfer used after remeshing is based on projection methods involving finite volumes [3]. The presented model is then compared against a 2D numerical simulation of Direct Energy Deposition of a High-Speed Steel thick deposit from the literature [4].