Energy performance of different photovoltaic module technologies under outdoor conditions

Cañete, Cristina; Carretero, J.; Sidrach‐de‐Cardona, M.

doi:10.1016/j.energy.2013.12.013

Cited by 128 publications

(74 citation statements)

References 16 publications

Supporting

Mentioning

Contrasting

Unclassified

Order By: Relevance

“…Sistem bileşenlerinin nominal karakteristik değerleri, sistem konfigürasyonu, sistemin bulunduğu coğrafi alan koşulları, sistem çevresinde bulunun gölgelenmeye neden olabilecek yapılar ve sistemin çalışma esnasında oluşabilecek elektronik arızalar gibi sorunlar sistemin enerji üretiminde kayıplara sebep olup, sistemin verimliliğine etki etmektedirler. PV sistemlerin Performans Oranı (PO) [3][4].…”

Section: Fotovoltaik Sistemlerde Performans Oranıunclassified

Batman ilindeki ince film a-Si teknolojili fotovoltaik sistemin performans değerlendirmesi

Pakma

2017

Balıkesir Üniversitesi Fen Bilimleri Enstitüsü Dergisi

View full text Add to dashboard Cite

show abstract

Section: Fotovoltaik Sistemlerde Performans Oranıunclassified

Batman ilindeki ince film a-Si teknolojili fotovoltaik sistemin performans değerlendirmesi

Pakma

2017

Balıkesir Üniversitesi Fen Bilimleri Enstitüsü Dergisi

View full text Add to dashboard Cite

show abstract

“…PR does not represent the amount of generation power, because a system with high PR in low solar resource might produce less energy than a system with a low PR under high solar resource condition. This is widely used to evaluate PV plants around the world because it is largely independent on the orientation of the PV plant and the incident solar radiation [11][12][13]. It could be evaluated about the power generation performance loss of PV system or occurrence of problem.…”

Section: Performance Coefficient Of Performance Ratio (Pr)mentioning

confidence: 99%

“…The performance ratio is a purely definition-based variable, which, under the influence of following factors, may even exceed value of 100%. Deviations in real operating conditions influence the performance ratio [10][11][12][13][14][15][16]. When the PR decreases moderately, this represents the PV system has less critical problems.…”

Section: Pr=mentioning

confidence: 99%

Performance Ratio of Crystalline Si and Triple Junction a-Si Thin Film Photovoltaic Modules for the Application to BIPVs

Cha¹,

Jae-Woo²,

Lim³

et al. 2017

Transactions on Electrical and Electronic Materials

View full text Add to dashboard Cite

The building integrated photovoltaic system (BIPV) attracts attention with regard to the future of the photovoltaic (PV) industry. It is because one of the promising national and civilian projects in the country. Since land area is limited, there is considerable interest in BIPV systems with a variety of angles and shapes of PV panels. It is therefore expected to be one of the major fields for the PV industry in the future. Since the irradiation is different from each installation angle, the output can be predicted by the angles. This is critical for a PV system to be operated at maximum power and use an efficient design. The development characteristics of tilted angles based on data results obtained via longterm monitoring need to be analyzed. The ratio of the theoretically available and actual outputs is compared with the installation angles of each PV module to provide a suitable PV system for the user.

show abstract

“…The unit cost of energy is 0.119 TL. It pays off in 6.2198 years [39][40][41][42]. The annual financial balance of the photovoltaic generator is shown in Figure 11.…”

Section: Cost Analysismentioning

confidence: 99%

Performance analysis of a 500-kWp grid-connected solar photovoltaic power plant in Kahramanmaraş

Yılmaz¹,

Özçalık²

2015

Turk J Elec Eng & Comp Sci

View full text Add to dashboard Cite

In today's world, the daily need for and cost of energy sources increase and this forces industrial institutions to seek for new ways to generate their own energy. The developments in photovoltaic systems have recently drawn attention in the business world. Although their installation costs are high, they are environmentally friendly and profitable investments in the long run. The cost analysis of a large-scale photovoltaic generator in the climatic conditions of Kahramanmaraş will lead the way to new investments. In this study, the modeling and cost analysis of an on-grid photovoltaic generator of 500 kW, which was installed to provide energy for a textile factory located in the Pazarcık district of Kahramanmaraş Province (37.5• N, 37.

show abstract

Energy performance of different photovoltaic module technologies under outdoor conditions

Cited by 128 publications

References 16 publications

Batman ilindeki ince film a-Si teknolojili fotovoltaik sistemin performans değerlendirmesi

Batman ilindeki ince film a-Si teknolojili fotovoltaik sistemin performans değerlendirmesi

Performance Ratio of Crystalline Si and Triple Junction a-Si Thin Film Photovoltaic Modules for the Application to BIPVs

Performance analysis of a 500-kWp grid-connected solar photovoltaic power plant in Kahramanmaraş

Contact Info

Product

Resources

About