2011
DOI: 10.1016/j.jpowsour.2010.09.027
|View full text |Cite
|
Sign up to set email alerts
|

Enhanced electrochemical properties of Li(Ni0.4Co0.3Mn0.3)O2 cathode by surface modification using Li3PO4-based materials

Help me understand this report

Search citation statements

Order By: Relevance

Paper Sections

Select...
3
1
1

Citation Types

3
65
0

Year Published

2014
2014
2024
2024

Publication Types

Select...
10

Relationship

3
7

Authors

Journals

citations
Cited by 127 publications
(68 citation statements)
references
References 29 publications
3
65
0
Order By: Relevance
“…The broad semicircle may consist of two overlapped semicircles. Generally, a semicircle in a high-frequency range shows impedance attributed to a solid electrolyte interface, while a semicircle in a relatively low-frequency range represents the charge-transfer resistance [34,35]. The size of the semicircle depends on the impedance value.…”
Section: Resultsmentioning
confidence: 99%
“…The broad semicircle may consist of two overlapped semicircles. Generally, a semicircle in a high-frequency range shows impedance attributed to a solid electrolyte interface, while a semicircle in a relatively low-frequency range represents the charge-transfer resistance [34,35]. The size of the semicircle depends on the impedance value.…”
Section: Resultsmentioning
confidence: 99%
“…The R ct showed rapid increase with cycling, which was understood as the micro-crack defects increase with charge-discharge cycling and it, in turn, causes disintegration of active material which increase the R ct [40,41]. Park et al [42,43] and Lee et al [44] reported that it predominantly due to the side reactions arising from liquid electrolyte decomposition at high voltage, a resistive layer may impede ionic transport via the interface between cathode materials and liquid electrolyte, which would consequently have a detrimental effect on cycle performance of high voltage charged cells. It can be seen that the value of the pristine LiCoO 2 cells before cycle is 31.5 V but considerably increases after 50 cycles reached to 465 V. However, the R ct of the coated samples increases slowly especially for 3.0 wt.…”
Section: Electrochemical Impedancementioning
confidence: 99%
“…However, the energy densities of commercial Li-ion batteries using LiCoO 2 as a cathode cannot satisfy the demand of many of these applications [6][7][8][9][10]; new high-capacity cathode materials are therefore required. The layered Li-rich materials in the Li-Mn-Ni oxide system, which have higher energy densities (~250 mAh g −1 ) than other cathode materials such as LiCoO 2 [11][12][13][14][15][16][17][18], have attracted significant attention as promising new cathode materials.…”
Section: Introductionmentioning
confidence: 99%