Enumeration and Analysis of DC–DC Converter Implementations Based on Piezoelectric Resonators

Abstract

Demand for power electronics with smaller volume, lighter weight, and lower cost will eventually require new converter energy storage technologies with fundamentally higher power density and efficiency limits. This motivates investigation into piezoelectric resonators (PRs), which offer very high power density and efficiency capabilities and significantly improved scaling properties compared to magnetics. PRs have been used in power conversion previously, but the realm of possible converter implementations using only PRs for energy storage has seen little exploration. In this work, we enumerate and evaluate dc-dc converter topologies and switching sequences that best utilize a PR as the only energy storage component, and that enable low-loss resonant "soft charging" of the PR's input capacitance with voltage regulation capability. To compare these implementations, we present analysis techniques for their operation and periodic steady-state solutions considering practical constraints. In addition, we provide useful techniques for estimating PR utilization and efficiency, which we validate experimentally in a 200-100-V, 25-W rated prototype. This prototype exhibits peak efficiency >99% as well as high efficiency (≥96%) across a wide range of operating conditions, illustrating the promise of PR-based converters for high voltage, low power applications. This article is accompanied by an instructional video for selecting and analyzing PR-based dc-dc converter implementations. Index Terms-Converter topologies, dc-dc power converters, piezoelectric resonators (PRs), piezoelectric transducers, soft charging, switching sequences, zero voltage switching (ZVS). I. INTRODUCTION P OWER electronics face ever-increasing demands for miniaturization, integration, and lower cost that are becoming challenging to meet with conventional design strategies.

A Stacked Piezoelectric Converter Using a Segmented IDT Lithium Niobate Resonator

“…Fig. 3(a) shows a configuration where the input and output ports of a single switching cell are stacked, henceforth referred to as the "single-stacked" topology [7], [8], [17]. Fig.…”

“…The switching sequence of the switching cell is analyzed in detail by [17], and the impact of switch capacitance is analyzed in [7]. In Fig.…”

DC Charger Circuit Optimization Design and Fast Charging and Discharging Mechanism Research

“…At present, there are two main types of soft-switching DC/DC converters on the market: zero-switching PWM and harmonic mode converter [44].The single phase shift modulation method is the earliest phase shift modulation method, which can realize the bidirectional transmission of energy, and its waveform is shown in Fig. 4 (a).…”

Inductorless Step-Up Piezoelectric Resonator (SUPR) Converter: A Describing Function Analysis

“…Pollet et al [14] presented a novel piezoresonator based boost converter, showing significant voltage gain and good efficiency. Boles et al [15] presented several new topologies of PR converters, each offering unique operating voltage ranges, efficiencies and output voltages. Touhami et al [16] presented a new PR converter offering improved performance over those presented by Boles et al, with an output power of 175W at 80% efficiency, significantly higher output power than previous PR converters and higher than PT based converters [17].…”

“…In [15], Boles et al applied a modelling approach to several topologies of PR converter. However, obtaining an accurate estimation of the switch timings using this method requires the solution of 15 equations with 18 variables, which is highly computationally complex.…”