2024
DOI: 10.1016/j.jmrt.2024.01.203
|View full text |Cite
|
Sign up to set email alerts
|

Epitaxial growth of rare-earth yttrium on nanosheets to form semicoherent interface in zinc implant

Cijun Shuai,
Jin Zhang,
Youwen Yang
et al.
Help me understand this report

Search citation statements

Order By: Relevance

Paper Sections

Select...
2
1
1
1

Citation Types

0
6
0

Year Published

2024
2024
2024
2024

Publication Types

Select...
9

Relationship

3
6

Authors

Journals

citations
Cited by 26 publications
(6 citation statements)
references
References 48 publications
0
6
0
Order By: Relevance
“…Therefore, the texture intensity on the horizontal plane was smaller than that on the vertical plane (15.91 MUD). It has been reported that the weakening of texture has a positive effect on the enhancement of mechanical strength [35]. The bimodal grain structure of the LPBF-printed pure Zn was revealed through high-magnification EBSD as depicted in figure 6.…”
Section: Microstructurementioning
confidence: 94%
“…Therefore, the texture intensity on the horizontal plane was smaller than that on the vertical plane (15.91 MUD). It has been reported that the weakening of texture has a positive effect on the enhancement of mechanical strength [35]. The bimodal grain structure of the LPBF-printed pure Zn was revealed through high-magnification EBSD as depicted in figure 6.…”
Section: Microstructurementioning
confidence: 94%
“…First, PLLA and other powders are mixed in a certain proportion for grinding and then magnetically stirred with alcohol for a certain period before drying. The ratio of SnS 2 , Mxene, and MXene/SnS 2 4 wt % in the composite powder was determined by previous pre-experiments due to the formation of composite scaffolds being difficult when the ratio is more than 5 wt % . The optimal process parameters were chosen as follows: power: 7.5 W, sweep interval: 0.10 mm, and pulse width: 10 μs .…”
Section: Methodsmentioning
confidence: 99%
“…The ratio of SnS 2 , Mxene, and MXene/SnS 2 4 wt % in the composite powder was determined by previous pre-experiments due to the formation of composite scaffolds being difficult when the ratio is more than 5 wt %. 22 The optimal process parameters were chosen as follows: power: 7.5 W, sweep interval: 0.10 mm, and pulse width: 10 μs. 23 The laser beam traversed the powder surface at a rapid pace of 200 mm/s, while the workbench temperature was up to 120 °C.…”
Section: Physicochemical Characterizationsmentioning
confidence: 99%
“…where rd r is the relative density, and td r is the theoretical density of Fe 81 Ga 19 alloy (7.8 g cm −3 ) [33]. To minimize inaccuracies in measurement, four replicate measurements were conducted for each group, and the average values were considered as the eventual results [34].…”
Section: Density Testsmentioning
confidence: 99%