Osmotic membrane bioreactor (OMBR) is an emerging membrane process which has gained interest in the recent years because of the low energy consumption and the high effluent quality. The osmotic membrane bioreactor combines a forward osmosis (FO) membrane and a biological treatment. However, salt reverse flux is the main problem because of the negative effect of the salt concentration increase in the reactor on the microbial activity. This is the reason why the study of a suitable draw solution (DS) is very important in the overall performance of the reactor. This study compares the process performance using two draw solutions: a 53 g•L-1 NaCl solution and a real waste water solution (waste water from an absorption column consisting mainly of SO4-2 and NH4-N with concentrations of 153 g•L-1 and 19 g•L-1 , respectively). The comparison is focused on the salt reverse flux during the reactor operation, the mixed liquor characteristics, the membrane fouling and the overall performance. The results indicated that the industrial wastewater showed a higher salt reverse flux, but also a less severe fouling and a higher the osmotic pressure difference in comparison with the NaCl solution. In terms of chemical oxygen demand (COD) removal efficiencies, both draw solutions attained values higher than 80%, though the efficiency was slightly lower when the industrial effluent was used as DS. This was related to the higher conductivity reached in the bioreactor when the industrial effluent was used as draw solution. In spite of it, the use of this industrial effluent as draw solution is strongly recommended because of the high permeate fluxes yielded, the low membrane fouling and the lack of necessity of regenerating the draw solution.