Evaluating the tephra input into Pacific Ocean sediments: distribution in space and time

Abstract

We studied the volcanic contribution to the global sediment budget in the Pacific Ocean basin. It is the world's oldest (174 m.y.) and largest (≈49% of Earth's surface area) ocean basin and has had a high and continuous tephra influx from intraplate and convergent margin volcanoes through time. Computerized shipboard data from 65 legs of the Deep Sea Drilling Project (DSDP) and the Ocean Drilling Program (ODP) were screened for the presence of volcaniclastic components. Tephra-bearing and tephra-free core sections (standard 1.5-and 0.30-m core catcher sections) were separated, regardless of the mass fraction of tephra present. The percentage of tephra-bearing core sections ("tephra frequency") per site and time span ("age unit") was calculated. The age units were the Quaternary, the subepochs of the Tertiary, and the stages of the Cretaceous. A total of 424 drill sites yielded 1433 usable stratigraphic units. Fifty percent are younger than 13 m.y., corresponding to only approximately 10% of the total interval studied (124.5 m.y.). The percentage of tephra-bearing age units is high throughout (83±6%) and correlates linearly with the total number of age units (R 2 =0.998; n=17). The average tephra frequency (30-50%) fluctuates, because the abundance of age units of different tephra frequency classes (0, 1-33, 34-67, 68-100% tephra frequency) varies with time. This indicates that the Cenozoic increase in tephra production results from increase in volcanicity and not spatial extension of volcanic source areas. The Cenozoic sediments that were recovered are dominated by distal tephra from explosive arc volcanism. Pulses of arc volcanism occurred in the Pliocene-Quaternary (since ≈5 m.y.) and midMiocene (≈12-15 m.y.). However, the record of explosive arc volcanism in Paleogene and Cretaceous sediments was either not drilled or has been destroyed by subduction. Except for the Cretaceous (≈70-110 m.y.) volcanic pulse, intraplate volcanism is poorly represented in the tephra record because the drill sites are outside the proximal range (>500-1000 km) of the sources. Thus, the tephra record drilled contains significant gaps that bias the estimate of tephra volume towards the less voluminous distal deposits. Most of the volcaniclastic volume accumulated by mass wasting as volcaniclastic aprons surrounding ocean island volcanoes. Volcaniclastic production rates range from 10,000 to 41,800 km 3 /m.y. for large intraplate volcanoes and approximately 10-13 km 3 /km arc length per million years for oceanic island arcs. Extrapolation over the lifetime of major Pacific arcs and hotspot chains, combined with a volume estimate of the distal tephra component, indicates a minimum of 9.3×10 6 km 3 of tephra, corresponding to 23 vol.% of the existing Pacific oceanic sediments. At least two thirds of the tephra volume was deposited in the proximal range and at least half of it is derived from intraplate sources. The large proportion of tephra, its composition, and its localized accumulation causes significant spatial and temporal variati...

Construction of volcanic records from marine sediment cores: A review and case study (Montserrat, West Indies)

“…Indeed, this issue is likely common to all ocean sediments lying in areas influenced by deposition of volcanic material. Such areas may not simply be restricted to locations immediately around active island volcanoes, as exemplified by estimates Page | 23 that ~25% of Pacific Ocean sediment comprises volcanogenic material (Straub and Schmincke, 1998). …”

The role of airborne volcanic ash for the surface ocean biogeochemical iron-cycle: a review

“…Such input would be enough to cause significant MPP response in an iron-limited (HNLC) oceanic area, as >2 nM Fe-increase were shown in mesoscale ironenrichment experiments to be sufficient to stimulate a massive phytoplankton bloom (Wells, 2003). Further, deep oceanic sediments, including those in iron-limited HNLC areas, contain ash layers with thickness on the mm-, dm-and even up to the meter-scale (Straub and Schmincke, 1998). Thus, heavy volcanic ash fall may swamp the surface of the ocean with iron, at least within the ash fall-out area.…”

Iron biogeochemistry across marine systems – progress from the past decade

“…Jones and Gislason, 2008;Duggen et al, 2007;Frogner et al, 2001). Drill core data from scientific ocean drilling show that volcanic ash layers and dispersed ash particles are frequently found in marine sediments and that volcanic ash deposition and therefore iron-injection into the oceans took place throughout much of the Earths history (Straub and Schmincke, 1998). It may thus well be possible that the contribution of volcanic ash to the marine biogeochemical ironcycle is generally underestimated.…”