Evaluation of Pore-Former Size and Volume Fraction on Tape Cast Porous 430 Stainless Steel Substrates for Plasma Spraying

Abstract

Porous 430L stainless steel disks made by tape casting with various pore-former sizes and volume fractions were evaluated as substrates for solid oxide cell (SOC) fabrication by plasma spraying. This work reports the substrate properties relevant to the SOC operation of disks made by using extra fine metal powder with dense sintering to minimize the fine porosity between particles. In contrast, the coarse porosity is introduced by the pore former. We found that the 60 μm pore former at a 45 vol% fraction has the best application fit; it gives an adequate gas permeability of 3.11 × 10−13 m2 and an average open pore size of 45.90 μm. Compared to a commercial substrate with a similar porosity perimeter/steel area ratio, the porosity and gas permeability are 1.6 and 3 times higher, respectively. The detected maximum surface pore is 49 μm, allowing gas-tight electrolytes fabricated by plasma spray deposition.