Evaluation of recycled galvanised steel as a resource for Zn production

Abstract

The high reduction potential of zinc has enabled its extensive use in the steel industry as a protective galvanising coating. Galvanising, which consumes approximately 50-60% of the global production of zinc, significantly increases the life span of steel products and contributes towards addressing the costly global problem of corrosion. While there does not appear to be a readily available and agreed-upon annual quantity of galvanised steel produced, it has been estimated by the authors to be 320-390 Mt/a (equating to 15-20% of the annual steel production). Due to the various methods employed to galvanise steel and different steel shapes which are coated, there is no clarity on the average percentage of zinc which galvanised steel is comprised of. However, a zinc content of between 1.5-2.5% appears to correlate with the estimated annual galvanised steel production. The reprocessing of secondary zinc streams is becoming increasingly important due to legislation changes and increased consumer demand for recycled and low carbon metals. Within the steel industry this will include the recycling of galvanised scrap steel, using primary process routes, as well as the re-processing of waste streams, such as steel dusts, using additional technologies such as the Waelz kiln. Zinc associated with galvanised scrap steel would exclusively report to these dusts, and thus represents a key resource for recycled zinc. Although there are two main steel process routes preceding the galvanising process, the focus here is on the Electric Arc Furnace (EAF) process route due to its ability to incorporate high levels of secondary (zinc containing) steel feeds, and the dust produced typically contains economically recoverable levels of zinc. EAF dust production is estimated between 5-10 Mt/a at a zinc content of 10-36%. Failure to recover this zinc would represent a loss of 0.5-3.6 Mt Zn/a to waste. The Waelz kiln is the most prominent technology utilised to recover Zn from EAF dust. However, this process requires additional energy, and thus the associated carbon footprint needs to be included in the evaluation of the potential of Waelz oxide as a secondary Zn resource. To this end, model analysis of a simplified Waelz kiln using the HSC simulation software shows that the carbon footprint associated with the processing of EAF dust ranges from 4-12 kg CO2/kg Zn dust at 10 wt.% Zn in the dust to 1-4 kg CO2/kg Zn at 35 wt.% Zn in the dust.