Evaluation of sensitization and corrosive damages of the weldment for SUS 316 stainless steel

Austenitic stainless steels are the wide-spread materials, used mainly in the power industry. In that kind of engineering application, structural parts of rotating elements reach during their lifetime very high numbers of loading cycles, exceeding 107 numbers of cycles. With regard to this fact, the data of ultra-high cycle fatigue properties are needed to be used in the qualified design. Increasing demands on the efficiency cause the increase of the operating temperature, and exposition of these materials to the elevated temperatures can cause some important structural changes, which result in the sensitising of the structure. In this study authors present their own experimental results about fatigue properties of AISI 316Ti austenitic stainless steel after sensitising, in the ultra-high cycle region (Nf = 106 ~ Nf = 3×109 cycles). Fatigue tests were carried out using ultrasonic fatigue testing device with frequency f = 20 kHz at the coefficient of cycle asymmetry R = -1, and temperature T = 20±5°C. In the ultra-high cycle region was observed the continuous decrease of the fatigue properties of the AISI 316Ti, and there was recorded the negative effect of the sensitising on the ultra-high cycle fatigue properties of the AISI 316Ti.

show abstract

scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.

Contact Info

customersupport@researchsolutions.com

10624 S. Eastern Ave., Ste. A-614

Henderson, NV 89052, USA

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

Blog Terms and Conditions API Terms Privacy Policy Contact Cookie Preferences Do Not Sell or Share My Personal Information

Made with 💙 for researchers

Part of the Research Solutions Family.

Evaluation of sensitization and corrosive damages of the weldment for SUS 316 stainless steel

Cited by 3 publications

References 1 publication

Formation of nano martensite grain with specific angle grain boundary during the drawing process of 316L stainless steel

Formation of nano martensite grain with specific angle grain boundary during the drawing process of 316L stainless steel

Giga-cycle Fatigue of AISI 316L After Sensitising of Structure

Influence of structure sensitising of the AlSi 316Ti austenitic stainless steel on the ultra-high cycle fatigue properties

Contact Info

Product

Resources

About