Evaluation of the Effect of Holding the Mandrel in the Extreme Position of the FQM Mill on the Formation of Surface Defects

Abstract

Modern continuous mills FQM are high-performance technological units that allow you to get products of a wide range. The paper presents the results of the study of the effect of the time of holding the mandrel in the extreme position of the continuous mill FQM (Fine Quality Mill) on the probability of defect formation of surface defects. The problems of сcomputational simulation of the process of continuous rolling of pipes were set and solved. It is established that the increase in the holding time of the mandrel allows to reduce the sliding of the metal on the surface of the tool, and contributes to a stable process of removing the mandrel without the formation of defects on the inner surface of the draft pipe. The results of solving the problems of сcomputational modeling allowed to formulate technical recommendations aimed at reducing the probability of surface defects in the production of pipes at the FQM mill.