Evolution Law of Dominant Flow Channel and Enhanced Oil Recovery Measures for Water Flooding in Reservoirs with Partially Sealed Faults

Abstract

The presence of strongly sealed faults can divide a reservoir into complex fault blocks, while partially sealed faults can be created by farewell faults within each block, leading to more intricate fluid migration and residual oil distribution. However, oilfields often overlook these partially sealed faults, focusing instead on the entire fault block, which can impact the efficiency of the production system. In addition, the current technology struggles to quantitatively describe the evolution of the dominant flow channel (DFC) during the water-flooding process, especially in reservoirs with partially sealed faults. This limits the ability to formulate effective enhanced oil recovery measures during the high water cut stage. To address these challenges, a large-scale sand model of a reservoir with a partially sealed fault was designed, and water flooding experiments were conducted. Based on the results of these experiments, a numerical inversion model was established. By combining percolation theory and the physical concept of DFC, a new method was proposed to quantitatively characterize DFC using a standardized flow quantity parameter. The evolution law of DFC was then studied, considering the variations of volume and oil saturation of DFC, and the water control effect of different measures was evaluated. The results revealed that, during the early stage of water flooding, a vertical uniform dominant seepage zone formed near the injector. As the water was injected, DFCs from the top of the injector to the bottom of the producers gradually formed in the unoccluded area. However, DFC was only formed at the bottom in the occluded area. During water flooding, the volume of DFC in each area gradually increased and then tended to stabilize. The development of the DFC in the occluded area lagged behind due to gravity and fault occlusion, leading to the formation of an unswept area near the fault in the unoccluded area. The volume of the DFC in the occluded area was the slowest, and the volume was the smallest after stabilization. Although the volume of the DFC near the fault in the unoccluded area grew the fastest, the volume was only higher than that in the occluded area after stabilization. During the high water cut period, the remaining oil was mainly distributed in the upper part of the occluded area, the area near the unoccluded fault, and the top of the reservoir in other areas. The plugging of the lower part of the producers can increase the volume of DFC in the occluded area, and the DFC moves up throughout the entire reservoir. This improves the utilization degree of the remaining oil at the top of the entire reservoir, but the remaining oil near the fault in the unoccluded area remains inaccessible. The combination of producer conversion, drilling infill wells, and producer plugging can alter the injection−production relationship and weaken the occlusion effect of the fault. The occluded area forms a new DFC, leading to a significant increase in the recovery degree. The deployment of infill wells near the fau...