Exchange biasing of magnetoelectric composites

Abstract

Magnetoelectric composite materials are promising candidates for highly sensitive magnetic-field sensors. However, the composites showing the highest reported magnetoelectric coefficients require the presence of external d.c. magnetic bias fields, which is detrimental to their use as sensitive high-resolution magnetic-field sensors. Here, we report magnetoelectric composite materials that instead rely on intrinsic magnetic fields arising from exchange bias in the device. Thin-film magnetoelectric two-two composites were fabricated by magnetron sputtering on silicon-cantilever substrates. The composites consist of piezoelectric AlN and multilayers with the sequence Ta/Cu/Mn(70)Ir(30)/Fe(50)Co(50) or Ta/Cu/Mn(70)Ir(30)/Fe(70.2)Co(7.8)Si(12)B(10) serving as the magnetostrictive component. The thickness of the ferromagnetic layers and angle dependency of the exchange bias field are used to adjust the shift of the magnetostriction curve in such a way that the maximum piezomagnetic coefficient occurs at zero magnetic bias field. These self-biased composites show high sensitivity to a.c. magnetic fields with a maximum magnetoelectric coefficient of 96 V cm(-1) Oe(-1) at mechanical resonance.

Laser-induced precession of magnetization in ferrimagnetic GdFe thin films with low power excitation

“…This inference is supported qualitatively by the temperature dependence of the anisotropy field determined experimentally from magnetization curves along the hard (in-plane) axis: the value of H ani was determined by the extrapolation of the linear region obtained along the hard axis to the value of the saturation magnetization. 20,21 As shown in the inset of Fig. 2(b at around RT, the temperature increase due to irradiation with laser pulses is estimated to be…”

Challenges and opportunities for multi-functional oxide thin films for voltage tunable radio frequency/microwave components

“…109,117,118 The ME effect offers an alternative passive approach to magnetic field sensing and the effect is largest for composites consisting of piezoelectric and magneto-strictive layers laminated together, in either longitudinal-transverse (L-T) or longitudinallongitudinal (L-L) vibration modes. At 1 Hz, the sensitivity limit to minute magnetic field variations was about 5 pT/Hz 1/2 .…”

“…109,117,118 A majority of these are made of ferromagnetic and ferroelectric layers. The coupling between the two subsystems, termed ME interaction, is mediated by mechanical strain.…”

“…Some recent studies show comparable sensitivities in miniature sensors of piezoelectric AlN-ferromagnetic alloys. 109,118 3. Broadband miniaturized antenna structures utilizing magneto-electric materials Antenna miniaturization has been the subject of interest for more than half a century, but in recent years, it has received significant attention because of additional demand for numerous mobile communication systems on a single platform.…”

“…Thus, development of consistent and predictable tunable device performance requires the development of "wafer scale" BST film property control and uniformity. [118][119][120][121] To date, the best capacitance tuning ratio, highest Q factor and the K-factor have been obtained on sapphire substrates, with the thickness of BST layer >0.5 lm, and bottom metal layer stack of Ti/Pt/Au/Pt. 123 Subramanyam et al studied the effect of BST layer thickness on the varactor devices with the metal layers kept the same, and the geometry of the parallel plate varactor devices kept the same.…”