Experimental and Economic Analysis of the Thermal Solvent and Hybrid Solvent Processes

Abstract

Several partially scaled laboratory model experiments were conducted to evaluate a hybrid solvent-steam process for recovery of heavy oil or bitumen. All experiments used Athabasca UTF bitumen, and modelled a 30-metre-thick formation. The experiments were compared using a common set of economic assumptions. The experiments showed that a hybrid solvent-steam process could recover bitumen at steam-oil ratios much lower than those observed for steam assisted gravity drainage (SAGD), and achieve reasonable ultimate oil recovery (60% IOIP). The economic analysis based on experiments indicated that a hybrid solvent-steam process could be more cost-effective than SAGD for a 30-m Athabasca formation. Introduction Some heavy oil reservoirs are difficult to produce by cold production. The oil may be immobile at reservoir temperature, or there may be some initial oil mobility and some reservoir drive energy, but the sand strength precludes the production of wormholes. These reservoirs may contain dead oil, as in the case of Athabasca bitumen, or they may have some dissolved gas, as in the case of Cold Lake or Burnt Lake reservoirs. SAGD is the main commercial technology used for in-situ recovery of these oils. Because of the increasing costs for energy (natural gas) and the increasing restrictions on fresh water usage, solvent-based processes (VAPEX, Thermal Solvent, Hybrid Solvent, N-Solv, Savex) have been proposed as alternative technologies for heavy oil and bitumen production. Most of these technologies utilize a pair of horizontal wells, similar to those used in SAGD, but use a gaseous solvent, typically propane, alone or in conjunction with steam, to recover the oil. The VAPEX process may be augmented by adding heat. Heating of a horizontal wellbore will reduce bitumen viscosity sufficiently to produce a large increase in oil production rate. The heat also serves to initiate communication between the injector and the producer. The heat also serves to speed the diffusion of solvent into the oil. The combination of heated wellbores and VAPEX is known as the thermal solvent process.

Notice of Retraction: Economic Evaluation of Rational Well Spacing Density of Daqing Chaoyanggou Low Permeability Oilfield

“…But the investment of oilfield development also increases, it also means that total input increases [3]. The different between total output and total input is the net income.…”

Heavy-Oil Waterflooding: Back to the Future

“…Examples of using scaled apparatus to evaluate recovery process for heavy oil are found elsewhere 27 . In the case of SAGD, the scaling criteria used more extensively is the one proposed by Pujol and Boberg 28 .…”

“…In the case of SAGD, the scaling criteria used more extensively is the one proposed by Pujol and Boberg 28 . Frauenfeld et al 27 conducted a series of experiments to evaluate SAGD and ES-SAGD. The lab model was a sealed stainless steel canister placed in a pressure vessel and confined by nitrogen overburden, Figure 7.…”

An Investigation of Hybrid Steam-Solvent Injection for Increasing Economy and Reducing CO2Emission

“…Adding solvents into steam will be favorable because the cumulative cost per unit volume will decrease of approximately 13% compared to pure steam process (Frauenfeld et al, 2009). In this research, the hybrid steam-solvent injection was applied to the McMurray formation in Canada.…”