Experimental evaluation of theperformance of 2×2 MIMO-OFDM for vehicle-to-infrastructure communications

Abstract

In this paper, a novel 2 × 2 multiple-input multiple-output orthogonal frequency division multiplexing (MIMO-OFDM) testbed based on an Analog Devices AD9361 highly integrated radio frequency (RF) agile transceiver was specifically implemented for the purpose of estimating and analyzing MIMO-OFDM channel capacity in vehicle-to-infrastructure (V2I) environments using the 920 MHz industrial, scientific, and medical (ISM) band. We implemented two-dimensional discrete cosine transform-based filtering to reduce the channel estimation errors and show its effectiveness on our measurement results. We have also analyzed the effects of channel estimation error on the MIMO channel capacity by simulation. Three different scenarios of subcarrier spacing were investigated which correspond to IEEE 802.11p, Long-Term Evolution (LTE), and Digital Video Broadcasting Terrestrial (DVB-T)(2k) standards. An extensive MIMO-OFDM V2I channel measurement campaign was performed in a suburban environment. Analysis of the measured MIMO channel capacity results as a function of the transmitter-to-receiver (TX-RX) separation distance up to 250 m shows that the variance of the MIMO channel capacity is larger for the near-range line-of-sight (LOS) scenarios than for the long-range non-LOS cases, using a fixed receiver signal-to-noise ratio (SNR) criterion. We observed that the largest capacity values were achieved at LOS propagation despite the common assumption of a degenerated MIMO channel in LOS. We consider that this is due to the large angular spacing between MIMO subchannels which occurs when the receiver vehicle rooftop antennas pass by the fixed transmitter antennas at close range, causing MIMO subchannels to be orthogonal. In addition, analysis on the effects of different subcarrier spacings on MIMO-OFDM channel capacity showed negligible differences in mean channel capacity for the subcarrier spacing range investigated. Measured channels described in this paper are available on request. Keywords: MIMO-OFDM; Capacity; V2I; LOS; Channel Review IntroductionMultiple-input multiple-output (MIMO) systems have attracted considerable attention due to the increasing requirements of high capacity, spectral efficiency, and reliability in wireless communications. For example, MIMO systems have been adopted in the Long-Term Evolution (LTE) system, and it is expected that the upcoming developments in IEEE 802.11p and Digital Video Broadcasting Terrestrial (DVB-T) wireless standards will include the use of MIMO. It has been shown [1] that MIMO, *Correspondence: okechukwu.onubogu@qut.edu.au 1 School of Electrical Engineering and Computer Science, Queensland University of Technology, Brisbane, QLD 4001, Australia Full list of author information is available at the end of the article when deployed in a rich scattering environment, is capable of achieving high spectral efficiency, capacity, and reliability by exploiting the increased spatial degrees of freedom. MIMO is often combined with the orthogonal frequency division multiplexing (OFDM) in m...

Analog Radio-Over-Fiber Supported Increased RAU Spacing for 60 GHz Distributed MIMO Employing Spatial Diversity and Multiplexing

“…Theoretical models for mmW 2x2 MIMO predict that the optimal performance through LOS operation [20] for a wireless transmission distance of D can be achieved by having a transmit antenna separation given by = /2 cos( ) cos ( )…”

Experimental evaluation in wireless communications

“…Channel capacity of multiple-input multiple-output (MIMO) systems based on orthogonal frequency-division multiplexing (OFDM) in vehicular-toinfrastructure environments at 920 MHz was investigated in [4]. The authors also took into account the effects of channel estimation errors in the three different wireless systems considered in the measurement campaigns: IEEE 802.11p, Long-Term Evolution (LTE), and Digital Video Broadcasting (DVB)-T2.…”