2017
DOI: 10.22266/ijies2017.0831.18
|View full text |Cite
|
Sign up to set email alerts
|

Experimental Investigation and Multi Response Optimization of WEDM Process of AA7075 Metal Matrix Composites Using Particle Swarm Optimization

Abstract: Abstract:Wire electric discharge machining (WEDM) has turned out to be one of the well-known machining procedures utilized in bringing up elaborate aspects on electrically conductive substances. To improve the performance of WEDM process an attempt was made to improve the material removal rate (MRR) and minimize surface roughness (SR) on AA7075-activated carbon composites. The machined surface integrity associated with MRR and SR have been analysed as a function of processing parameters, such as discharge curr… Show more

Help me understand this report

Search citation statements

Order By: Relevance

Paper Sections

Select...
2
1
1
1

Citation Types

0
8
0

Year Published

2017
2017
2024
2024

Publication Types

Select...
6

Relationship

0
6

Authors

Journals

citations
Cited by 7 publications
(8 citation statements)
references
References 18 publications
0
8
0
Order By: Relevance
“…Successful welds of Aluminium and Copper with good joint integrities have also been reported [8]. Also, good weld joint efficiency in dissimilar joints between Mildsteel and AA6082 Aluminium alloy has been achieved [9].…”
Section: Fsw Of Dissimilar Materialsmentioning
confidence: 92%
See 1 more Smart Citation
“…Successful welds of Aluminium and Copper with good joint integrities have also been reported [8]. Also, good weld joint efficiency in dissimilar joints between Mildsteel and AA6082 Aluminium alloy has been achieved [9].…”
Section: Fsw Of Dissimilar Materialsmentioning
confidence: 92%
“…Compared grains can, now and again, be a sign for recrystallization and it can be accomplished by warm created because of rubbing between edges of the joint [7]. The fine microstructure in contact blend weld joint delivers great mechanical properties [8]. A schematic of the procedure is introduced in Figure. 1.…”
Section: Introductionmentioning
confidence: 99%
“…The ratio of feed rate to rotational speed is usually reduced to a singleparameter referred to as pitch. The properties of the welds are usually related to the pitch, which is believed to be animportant parameter in FSW [7]. …”
Section: Different Tool Geometry With Its Materials Welding Parametersmentioning
confidence: 99%
“…In view of different geometrical highlights of the device [4,5], the material development around the stick can be very mind boggling [6] During FSW process, the material experiences serious plastic disfigurement at hoisted temperature, bringing about age of fine compared gem grains. Compared grains can, now and again, be a sign for recrystallization and it can be accomplished by warm created because of rubbing between edges of the joint [7]. The fine microstructure in contact blend weld joint delivers great mechanical properties [8].…”
Section: Introductionmentioning
confidence: 99%
“…www.tjprc.org editor@tjprc.org thermal stability, and its dissolution point is much higher than the temperature of 600°C [19]. So the Mg-Zn phase with better thermal stability can be retained in the NZ after FSW.…”
Section: Microstructure Of Ze42 Magnesium Alloymentioning
confidence: 99%