Experimental investigation of linear low density polyethylene composites based on coir for rotational molding process

Abstract

Rotational Molding is a plastic manufacturing process mainly implemented to produce stress free hollow products. Linear Low Density Polyethylene (LLDPE) is widely preferred as base resin for molding roto molded product, but it displays moderate value in some critical applications where strength is the major criteria. Additives can fill the gap in sustaining the necessary strength needed. In the present work, an attempt has been made to analyze the optimum percentage of coir reinforced with LLDPE for rotational molding technique to provide requisite processability for rotational molding process. Coir in its powder form is mixed at concentrations varying in the range of 3% to 20% with respect to LLDPE. In order to justify the prerequisite of processability for rotational molding, various experiments namely FTIR, MFI, rheology and thermal analysis were conducted. FTIR suggested the range of 5% to 15% wherein the significance of LLDPE and coir peaks can be observed. MFI test supported FTIR result which ended in considering 3% to 12% by weight ratio suitable in terms of flow ability. Rheological and thermal analysis subjecting to shear and heat parameter respectively, confirmed the range of 10 weight percentage of coir or below is suitable in terms of material processability. From the experimental results, it is concluded that 10% or less concentration of coir fiber in LLDPE as an optimum range of blend yielding better processability for rotational molding process.

Preparing epoxidized vegetable oil from waste generated by the kapok fiber industry and assessing its thermal stabilization effect as a co-stabilizer for polyvinyl chloride

“…Both actions result in increased molecular weight, leading to higher viscosity and reduced flowability. As stated in the literature [ 81 , 82 ], MFI is inversely proportional to the molecular weight, meaning that the higher the molecular weight, the lower the MFI, and vice versa.…”

Development of an Ultrasonic Method for the Quality Control of Polyethylene Tanks Manufactured Using Rotational Molding Technology

“…The impact strength of the finished tanks is the most important characteristic for evaluating the quality of a product. It is determined, as a rule, by the conditions of the technological process [ 21 , 42 ] and the composition of the processed raw materials [ 43 , 44 , 45 , 46 , 47 , 48 , 49 , 50 , 51 ]. Therefore, in the RM industry, the issue of the precise control of the material sintering process is acute; currently, it is mainly carried out by monitoring PIAT.…”

Effect of industrially processed glass fibre dust on mechanical, thermal and morphological properties mixed with LLDPE for rotational molding process

“…The distinct intrigue manufacturing techniques to mold these materials dynamically include blow molding, injection molding, thermoforming, rotational molding, etc. [7][8][9].…”