Experimental Investigation of the Spatial and Temporal Evolution of the Tangential and Normal E-Field Components along the Stress Grading System of a Real Stator Bar

Abstract

This paper presents results based on direct experimental measurements of tangential (Et) and normal (En) E-field components along the stress grading system (SGS) of a real stator bar (Roebel type) for different AC 60 Hz applied voltages. These measurements were made with a new electro-optic system allowing for the study of both spatial distributions of two E-field components along the bar and their temporal evolution at critical points. The results obtained allowed us to calculate the correlation between the distribution of En and Et along the SGS. In particular, it was demonstrated that the En distribution presents a characteristic minimum, which can be used to identify the zone of partial discharge inception. Moreover, it was possible to observe an enlargement of the Et component distribution followed by a saturation in magnitude with the applied voltage increase. Moreover, the results have demonstrated that the waveform of the En component is mostly affected by the SG material used, producing a greater distortion in its waveform than those obtained for the Et component. The more significant distortion was obtained at the end of the outer corona protection (OCP) material, corresponding to the first maximum of the En component and characterized by the appearance of a third harmonic of large amplitude.

One-Dimensional Model for the Nonlinear Resistive Electric Field Control in Medium-Voltage Rotating Electrical Machines

“…in [7]. The available measured data on the resistive nonlinear properties of FGMs for medium voltage rotating electrical machines are depicted in Figure 3 [1, [7][8][9][10][11][12][13][14][15][16][17]. The data was reproduced from respective references at temperatures close to 80 C for comparative purposes.…”

“…Table 1 shows the dielectric properties of materials in Figure 3, which are estimated with Equation (11). The measured relative permittivity SGT of nonlinear resistive FGMs is in the range from 6 to 20 [7,8,[13][14][15][16]. The data in Table 1 shows markedly different nonlinear resistive properties of the materials studied.…”