Experimental study on the discharge characteristics of two eutectic solder packed bed latent heat storage systems

Abstract

Metallic solder based PCMs possess higher thermal conductivities, larger storage masses and exhibit lower subcooling effects compared to their organic or inorganic counterparts. It is thus justified to investigate their potential usage for medium temperature applications. These solders are relatively expensive and can be combined with cheaper PCMs in cascaded storage systems which are more thermodynamically efficient compared to single PCM systems as reported recently. The aim of the research is thus to compare two packed bed storage systems during discharging cycles using eutectic solder (Sn63/Pb37), that is widely available worldwide. The single PCM system (40 capsules) consists of encapsulated spheres of eutectic solder, whereas the second cascaded system consists of encapsulated spheres of eutectic solder and erythritol in an equal storage ratio in the tank. For the cascaded system, the eutectic solder capsules are placed at the top and erythritol at the bottom of the storage tank (20 capsules at the top and 20 at the bottom). The effect of the discharging flow-rates of 4 mL/s, 6 mL/s and 8 mL/s is investigated in relation to the temperature profiles, energy rates and exergy rates. Increasing the flow-rate, increases heat transfer rate thus shortening the discharging time as well as increasing thermal profile reversals during discharging. The peak energy and exergy rates increase with the increase in the flow-rate for the two storage systems. The single PCM system shows slightly higher average energy and exergy rates compared to the cascaded system possibly due to its higher thermal conductivity. The cascaded PCM system shows higher average stratification numbers at all the flow rates considered. The non-cascaded system exhibited slightly higher exergy recovery efficiencies compared to the cascaded PCM system possibly due to its higher thermal conductivity at all flow-rates considered. The effect of the initial discharging temperature is also investigated with a discharging flow-rate of 6 mL/s after charging with set heater temperatures of 260 C, 280 C and 300 C, respectively. Comparable thermal profiles are seen for both systems for the three set temperatures; however, the single PCM system shows slightly higher storage temperatures. The single PCM shows slightly higher but comparable peak and average discharging energy rates compared to the cascaded system. The exergy rates for the two systems are also comparable.