Extraction of cable joints tangent delta from bulk tangent delta measurement using HFAC method

Shafi, H.; Anthony, Tashia Marie; Basri, Ahmad Burhani Ahmad; Raj, Avinash; Chakrabarty, Chandan Kumar

doi:10.1109/pecon.2016.7951578

Cited by 3 publications

(2 citation statements)

References 5 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The experiments demonstrated a relationship between the temperature and the tangent delta, affecting the cable joint service life. In [26,27], different Tanδ extraction methods are presented.The pressure between the insulating elements and the cable joint is also believed to affect the insulation effectiveness provided by the cable joint. The selection of materials plays a relevant role in this respect [28].…”

mentioning

confidence: 99%

See 1 more Smart Citation

Effects of Thermal Cycles on Interfacial Pressure in MV Cable Joints

Sante

Ghaderi

Mingotti

et al. 2019

Sensors

View full text Add to dashboard Cite

The use of medium voltage cable joints is mandatory when dealing with power cable faults and the installation of new lines. However, such an accessory is among the top causes of faults among the grid. To this purpose, one of the quantities monitored to understand the causes of such faults is the interfacial pressure between the insulating layers of the cable joint. In this work, the interfacial pressure between Cross-linked polyethylene (XLPE) and silicon rubber has been evaluated when the cable joint experiences thermal cycles. From the results, the pressure variation caused by the thermal cycles is demonstrated. Such a phenomenon may be connected to the generation of voids and weak spots that accelerate cable joint ageing. Therefore, proper comments and conclusions are drawn.Sensors 2020, 20, 169 2 of 13 delta at ambient temperature. The same setup is then used to perform measurements in the 5-60 • C temperature range [25]. The experiments demonstrated a relationship between the temperature and the tangent delta, affecting the cable joint service life. In [26,27], different Tanδ extraction methods are presented.The pressure between the insulating elements and the cable joint is also believed to affect the insulation effectiveness provided by the cable joint. The selection of materials plays a relevant role in this respect [28]. A method is available in literature to calculate and simulate the surface pressure [29]. The correlation between the interfacial pressure and tangent delta has been explored in [30]. The variation of the interfacial pressure with the ambient temperature was also investigated [31].As for the PD, they are considered by several experts to be an effective method to assess the "healthy" status of the cable joints. Therefore, literature provides a high number of studies on this topic. For example, new PD extraction and analysis methods are presented in [32,33], while an on-line measurement setup is described in [34]. Based on these works [30,31], a correlation between the three physical parameters involved can be established.In light of the above mentioned, the aim of this paper is to measure and evaluate the interfacial pressure between XLPE and SR when subject to thermal cycles. Such cycles aim at reproducing the ambient temperature variations that a cable joint suffers during its working life. From the results, compared also with the current literature, it can be appreciated a typical behavior, due in this case by the thermal cycles, that is cause of ageing acceleration of cable joints (as detailed below).The paper is structured as follows. In Section 2 the measurement setup and the details of its elements are described. The experimental tests are described in Section 3, while Section 4 is dedicated to the results analysis and comparison with consistent literature. In Section 5, comments on the obtained results and conclusion are drawn.

show abstract

mentioning

confidence: 99%

mentioning

confidence: 99%