Fabrication and evaluation of PZT/Ag composites and functionally graded piezoelectric actuators

Abstract

Metallic Ag as the second phase was added into PZT ceramic matrix to fabricate piezoelectric composites and functionally graded actuators by gradually altering Ag concentration, aimed to improve mechanical properties and to solve possible interfacial debonding usually observed in conventional bimorph-type piezoelectric actuator. The PZT/Ag composites were obtained by directly co-firing PZT and Ag powders at 1200 • C for 1 h. The fracture strength σ f and fracture toughness K I C , as well as the corresponding piezoelectric properties, were firstly evaluated upon the PZT/Ag composites for Ag concentrations of 0-30 vol%. The mechanical properties for the PZT/Ag composites were found to be greatly enhanced compared with pure PZT ceramics: from 69 to 129 MPa for σ f and from 1.0 to 3.7 MPa.m 1/2 for K I C . With increasing Ag concentration, the piezoelectric constant d 33 of PZT/Ag composites was found to decrease from 419 to 86 pC/N. Then, a functionally graded actuator was fabricated and evaluated in terms of electric-induced curvature k. The PZT/Ag FGM actuator with size of 12 mm × 3 mm × 1 mm has a curvature k of 0.03-0.17 m −1 that corresponds to applied voltages of 100-500 V. A comprehensive comparison was made on the mechanical property enhancements by the metal particles dispersion, and the bending displacements produced by the FGM actuators between the PZT/Ag and previously fabricated PZT/Pt systems.

Reliability enhancement in nickel-particle-dispersed alkaline niobate piezoelectric composites and actuators

“…The experimental details of the production of LKNN/Ni FGM actuators and the evaluation of electric-field-induced curvatures can be found elsewhere. 18 …”

Modeling of functionally graded piezoelectric ultrasonic transducers

“…PZT) is used as the second phase, which is added into a metallic matrix by gradually altering the piezoelectric material concentration, as described in Refs. [15,16]. For non-FGP ultrasonic transducers only the PZT-5A piezoceramic material is used to represent the active element.…”

Propagation of gap waves between two functionally graded piezoelectric half-spaces

“…Recently, the development of material processing technologies allows the production of nonhomogeneous piezoelectric materials with functionally graded material properties (FGPMs) [7]. FGPMs offer various possibilities for new acoustic wave devices.…”

“…Wang [8] considered analytically the problem of mode III crack in a class of FGPMs in which the variations of the mechanical and electrical properties are proportional. In addition to the FGPM electromechanical transducers treated in [7], FGPMs as model actuators were proposed in [9]. It was recently also shown that the variation of the material properties of FGPMs can be used to design the distribution of the actuating shear stress under a piezoelectric actuator and reduce the stress concentration near the actuator edges [10].…”