Fabrication of Parylene-Based High-Aspect-Ratio Suspended Structure Using a Silicon-on-Insulator Wafer

Abstract

In this study, we fabricated a parylene-based high-aspect-ratio suspended structure using a definition silicon-on-insulator (SOI) wafer. In this process a silicon micro trench is used as a mold, in which parylene beams are fabricated through the deposition and removal of parylene in multiple stages, after which the structure is released in a hydrofluoric acid solution to remove the buried oxide layer in the SOI wafer, followed by supercritical drying for preventing stiction. Compared with conventional processes, our process exploits the advantages of the SOI wafer to eliminate the extra oxide mask or the support wafer for structure release, thereby reducing process complexity and cost. The reactive-ion etching (RIE) lag effect and notch effect are also considered in this paper. In this study, we fabricated the test devices of the parylene beams without voids inside, which were integrated with a thermal actuator and a comb-drive actuator. Compared with silicon suspended beams, the flexibility of the parylene beams and the uniformity of device thickness are suitable for actuators with large in-plane displacements and low driving forces, and also for sensors with high sensitivity. #

A Piezoelectric MEMS Speaker with a Combined Function of a Silent Alarm

“…Then, the back cavity was formed after etching barrier SiO 2 ( Figure 2 (a7)). Finally, a ~0.5-μm-thick layer of parylene C was deposited on the device surface and back cavity to avoid the influence of humidity on device performance by isolating water vapor ( Figure 2 (a8)) [ 39 , 40 , 41 ]. Of course, the functions of speaker and silent alarm are exclusive, so that a circuit rotation device and a wireless data transmission module need to be built to facilitate the conversion of functions and data transmission.…”