Failure Mechanism of Sn-Ag-Cu Flip-chip Solder Joints with Different Cu Weight Contents Under Comparatively Low Current Stressing

Lai, Yi‐Shao; Chiu, Ying-Ta

doi:10.1109/ectc.2007.373988

Cited by 6 publications

(1 citation statement)

References 19 publications

(18 reference statements)

Supporting

Mentioning

Contrasting

Order By: Relevance

“…has the longest mean time to fail (MTTF) but that at 160°C has the shortest one. The character η stands for the characteristic life from the weibull cumulative distribution, indicating that 63.2% of the population failures, while β is the weibull slope [11][12]. Therefore, MTTF is strongly dependent on temperature due to joule heating effect.…”

Section: Methodsmentioning

confidence: 99%

The effects of Ag content in the solder on electromigration behavior

Chiu

Shao

Yang

2015

2015 International Conference on Electronic Packaging and iMAPS All Asia Conference (ICEP-IAAC)

Self Cite

View full text Add to dashboard Cite

As the volume shrinking of electronic products becomes a trend, the dimensions of solder joints have devoted to scale down. With a smaller solder bump, the current density of solder bump gets higher. Electromigration becomes a very serious reliability issue. The two Ag-contents of SnAg solder bump influenced on electromigration lifetime in the fine pitch of the flip chip package. The tri-layer Ti/Cu/Ni UBM has a 75 µm in diameter and the bump pitch is 150 µm. The passivation opening is defined 50 µm on the Al trace of the chip. The metallization of 2-layer substrate is pre-solder on the Cu pad (SOP) and the diameter of the Cu pad is 105 μm. Two solder compositions, Sn2.4Ag and Sn1.3Ag, were stressed with 4.5×10 4 A/cm 2 at 150°C and 160°C. However, the lifetime at 150°C with 4.5×10 4 A/cm 2 is 2.35 times than one at 160°C. The electrical resistance changes with current stressing time have three modes of variation relation. The crack and void were observed at the cathode of solder bump. Therefore, the failure mode should correspond with the relation of resistance versus current stressing time. Before current stressing, it was not easy to distinguish the microstructure of Sn1.3Ag from Sn2.4Ag solder bump. The same kind of IMC was found at the chip side and substrate side in both two solder bumps. After current stressing of 4928h at 150°C with 4.5×10 4 A/cm 2 , all solder of the current bypassed solder bump (Sn1.3Ag) turned into IMC. The UBM has not been consumed completely. A lot of Cu 6 Sn 5 was observed at the cathode in the failed solder bump. After a prolonged time of current stressing, the electromigration induced not only the consumption of the UBM but also the dissolution of the Cu pad.

show abstract

Section: Methodsmentioning

confidence: 99%