Fractal surface maghemite nanoparticles prepared by co-precipitation: the influence of Iron concentration and base nature

Abstract

Two series of magnetic nanopowders were synthesized at room temperature starting from a mixture of iron II and III precursors, FeSO4 and FeCl3, respectively. Precipitation agents, as KOH and NaOH were used. While the concentration of the added ferrous and ferric solutions ranged between 0.1 M and 0.0125 M, the hydroxide solution concentration was maintained constant (1 M). TEM images of the samples showed that the particles shape changes from quasi spherical to spherical. For both series the crystallite size decreases with iron concentration, from 9 to 2 nm for KOH series and from 10 to 3 nm for NaOH series. Moessbauer Spectroscopy was signaling only Fe 3+ in the final spinel product. BET measurements revealed the material mesoporosity and fractal structure of maghemite nanoparticles that explain the unusual high surface area, ~240 m 2 /g. All the samples actually exhibit superparamagnetic behavior at room temperature with saturation magnetization up to 73 emu/g value closed to those of bulk maghemite.

Silica-Coated Magnetic Nanocomposites for Pb2+ Removal from Aqueous Solution

“…Average 10 nm diameter MNPs were obtained following a synthetic method previously reported [24]. To obtain an iron oxide-silica shell nanocomposite system with enhanced surface active area, the quantity of the TEOS used in the synthesis of MNPs 4 @SiO 2 was varied.…”

“…Separate batches of magnetic iron oxide nanoparticles were freshly obtained prior to each coating operation with various amounts of silica. MNPs were obtained by the alkaline reverse co-precipitation method using NaOH, following the synthetic strategy previously reported [24]. In particular, 43 mL FeCl 3 ·6H 2 O (0.1 M) and 25 mL FeSO 4 ·7H 2 O solutions (0.1 M) separately prepared were mixed and added to 25 mL NaOH solution (1 M).…”

Magnetic Nanoparticles: Synthesis, Characterization, and Their Use in Biomedical Field

“…The temperature requirement varies based on the precursor type [19]. To achieve a high degree of uniformity and a size ranging from 4 to 30 nm, the optimal temperature falls within the 100-350 • C range [31,32]. Some authors consider that the temperature, reaction time, type of surfactants and solvents, and aging period should be adjusted according to the desired shape and size [33,34].…”