Freezing and Thawing Processes of Highways in Kazakhstan

Abstract

This paper presents the results of an experimental study of freezing and thawing patterns of highways in Kazakhstan. Special sensors measure temperature and moisture change every hour in automatic mode. The purpose of this work is to develop a methodology for determining the depth of freezing of subgrade soils of roads of Kazakhstan, and the task is to establish the pattern of cold temperature change (temperature “0 °C”) through certain points (sensors) at any time. In the upper part of the pavement (up to 30–40 cm), the temperature changes in annual and daily cycles. As the depth increases, the daily temperature fluctuations disappear, leaving only the annual fluctuation. At a depth of 180 cm and below, temperature fluctuations occur only in the annual cycle. The freezing rate varied from 14 cm/day to 0.33 cm/day. The maximum freezing depth was 227 cm. The descending branch of thawing occurs almost uniformly, with an average rate of 6.25 cm/day to a depth of 220 cm; the average rate of the ascending branch of thawing is 0.9 cm/day. Asphalt–concrete layers of the pavement and the upper part of the subgrade were in a frozen state for 151 and 166 days, respectively. In the subgrade at the beginning and end of the cold period, there are abrupt changes in moisture, which are explained by phase transitions of the second order: the transition from the liquid state to the solid (ice) at the beginning of the cold period and the transition of moisture from the solid state to liquid at the end of the cold period.

Calculation and modeling of seasonally freezing soils of the road highway in the area of Kosshy (Astana, Kazakhstan) in Frost 3D program

“…Polyethylene membranes have high strength, resistance to corrosion and chemical influences, as well as good adhesion to concrete and other building materials. [3] Polymers have low thermal conductivity and volumetric heat capacity, so we use them to strengthen the vapor barrier on the ground. Epoxy resin was chosen for this work.…”