Gas phase electrocatalytic conversion of CO 2 to syn-fuels on Cu based catalysts-electrodes

Gutiérrez-Guerra, N.; Moreno-López, L.; Serrano‐Ruiz, Juan Carlos; Valverde, J.L.; Lucas-Consuegra, A. de

doi:10.1016/j.apcatb.2016.02.010

Cited by 92 publications

(78 citation statements)

References 41 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In addition to that, owing to favorable surface area and pores size, the performance of metal catalysts impregnated on CSAC shows better efficiency if compared to that in PKSAC. This trend is aligned with findings by Guera et al (2016) where limited surface area and low porosity of activated carbon small amount of adsorbed N 2 [14].…”

Section: No X Reductionsupporting

confidence: 92%

HC-SCR: NO_xReduction using Mn and Cu Catalysts Impregnated in Coconut and Palm Kernel Shell Activated Carbon

et al. 2016

View full text Add to dashboard Cite

Abstract. The characteristics of catalysts impregnated in coconut shell (CS) and palm kernel shell (PKS) activated carbon were determined as potential precursors of catalysts used in a flue gas denitrification system at low temperature. In this study, Manganese (Mn) and Copper (Cu) with metal loading of 8% were impregnated in the activated carbon (AC) before undergoing low temperature calcination process. The morphological properties of samples was analysed using Scanning Electron Microscopy (SEM) and Brunauer, Emmett and Teller (BET) was used to determine the surface area and pore size of samples. The exhaust gas from a diesel engine at a constant flow rate of 4L/min was passed through in a fixed-bed catalytic reactor containing the catalyst, and the concentration of NOx was measured for temperatures ranging from 150°C to 250°C. It was found that the CS catalysts (CS-Mn and CS-Cu) and PKS catalysts (PKS-Mn and PKS-Cu) have the potential to reduce NOx concentration, and results showed that the metal loading of 8% resulted NOx reduction ranging from ~48% to 64%.

show abstract

Section: No X Reductionsupporting

confidence: 92%

HC-SCR: NO_xReduction using Mn and Cu Catalysts Impregnated in Coconut and Palm Kernel Shell Activated Carbon

et al. 2016

View full text Add to dashboard Cite

show abstract

“…Acetaldehyde and methanol were the main reaction products obtained over samples 20% Cu-AC and 10% Cu-AC, respectively. In line with our results, acetaldehyde and methanol were previously obtained as main products over Cu-AC catalysts [17]. In the case of catalyst 50% Cu-AC, the high Cu particle size favored the production of methyl formate by dehydrogenation of methanol Reaction (7), as previously reported [33].…”

Section: Co 2 Conversion Electrocatalytic Experimentssupporting

confidence: 92%

“…The activated carbon support showed high Langmuir areas and total pore volumes (866 m 2 ·g −1 and 0.293 cm 3 ·g −1 , respectively), as previously reported in the literature [17,18]. As shown in Table 1, metal addition resulted in an important decrease of both the surface area and the total pore volume.…”

Section: Characterization Of the Cu Powder Catalysts And The Cu Electsupporting

confidence: 82%

“…As expected, the mean Cu particle size increased significantly with the metal loading. The Cu particle sizes obtained herein (10-40 nm) were similar to those measured for similar electrocatalytic systems prepared by direct impregnation with Cu precursor solutions [16,17,25].…”

Section: Characterization Of the Cu Powder Catalysts And The Cu Electsupporting

confidence: 79%

“…Most of these products have been previously obtained during the electrocatalytic conversion of CO 2 on Fe, Co, Pt, and Cu supported on carbon nanotubes [15,16,[26][27][28] and Cu supported on different carbonaceous supports (activated carbon, carbon nanofibers, and graphite) [17] at similar temperatures. These products reached maximum production rates after ca.…”

Section: Co 2 Conversion Electrocatalytic Experimentsmentioning

confidence: 99%

See 2 more Smart Citations

Low-Temperature Electrocatalytic Conversion of CO2 to Liquid Fuels: Effect of the Cu Particle Size

et al. 2018

View full text Add to dashboard Cite

A novel gas-phase electrocatalytic system based on a low-temperature proton exchange membrane (Sterion) was developed for the gas-phase electrocatalytic conversion of CO 2 to liquid fuels. This system achieved gas-phase electrocatalytic reduction of CO 2 at low temperatures (below 90 • C) over a Cu cathode by using water electrolysis-derived protons generated in-situ on an IrO 2 anode. Three Cu-based cathodes with varying metal particle sizes were prepared by supporting this metal on an activated carbon at three loadings (50, 20, and 10 wt %; 50% Cu-AC, 20% Cu-AC, and 10% Cu-AC, respectively). The cathodes were characterized by N 2 adsorption-desorption, temperature-programmed reduction (TPR), and X-ray diffraction (XRD) and their performance towards the electrocatalytic conversion of CO 2 was subsequently studied. The membrane electrode assembly (MEA) containing the cathode with the largest Cu particle size (50% Cu-AC, 40 nm) showed the highest CO 2 electrocatalytic activity per mole of Cu, with methyl formate being the main product. This higher electrocatalytic activity was attributed to the lower Cu-CO bonding strength over large Cu particles. Different product distributions were obtained over 20% Cu-AC and 10% Cu-AC, with acetaldehyde and methanol being the main reaction products, respectively. The CO 2 consumption rate increased with the applied current and reaction temperature.

show abstract

Devices

2021

Electrocatalysis in Balancing the Natural Carbon Cycle

View full text Add to dashboard Cite

Gas phase electrocatalytic conversion of CO 2 to syn-fuels on Cu based catalysts-electrodes

Cited by 92 publications

References 41 publications

HC-SCR: NO_xReduction using Mn and Cu Catalysts Impregnated in Coconut and Palm Kernel Shell Activated Carbon

HC-SCR: NO_xReduction using Mn and Cu Catalysts Impregnated in Coconut and Palm Kernel Shell Activated Carbon

Low-Temperature Electrocatalytic Conversion of CO2 to Liquid Fuels: Effect of the Cu Particle Size

Devices

Contact Info

Product

Resources

About

Gas phase electrocatalytic conversion of CO 2 to syn-fuels on Cu based catalysts-electrodes

Cited by 92 publications

References 41 publications

HC-SCR: NOxReduction using Mn and Cu Catalysts Impregnated in Coconut and Palm Kernel Shell Activated Carbon

HC-SCR: NOxReduction using Mn and Cu Catalysts Impregnated in Coconut and Palm Kernel Shell Activated Carbon

Low-Temperature Electrocatalytic Conversion of CO2 to Liquid Fuels: Effect of the Cu Particle Size

Devices

Contact Info

Product

Resources

About

HC-SCR: NO_xReduction using Mn and Cu Catalysts Impregnated in Coconut and Palm Kernel Shell Activated Carbon

HC-SCR: NO_xReduction using Mn and Cu Catalysts Impregnated in Coconut and Palm Kernel Shell Activated Carbon