Generalized model of multi-phase induction motor drive using matlab/simulink

Renukadevi, G.; Rajambal, K.

doi:10.1109/iset-india.2011.6145366

Cited by 45 publications

(23 citation statements)

References 20 publications

Supporting

Mentioning

Contrasting

Unclassified

Order By: Relevance

“…In recent years, there is a great interest in using the constructions of squirrelcage induction motors with the number of phases of the stator winding greater than three. Motors of this design are called multi-phase motors [2,[4][5][6][7][8][9].…”

Section: Introductionmentioning

confidence: 99%

Field-oriented control of five-phase induction motor with open-end stator winding

Listwan

Pieńkowski

2016

Archives of Electrical Engineering

View full text Add to dashboard Cite

Abstract:The mathematical model of the five-phase squirrel-cage induction motor and the system of the dual five-phase voltage source inverter have been presented. The control methods and control systems of the field-oriented control of the five-phase induction motor with an open-end stator winding are described. The structures of the direct fieldoriented control system (DFOC) and the Indirect Field-oriented control system (IFOC) with PI controllers in outer and inner control loops are analyzed. A method of space vector modulation used to control the system of the dual five-phase voltage source inverter has been discussed. The results of simulation studies of the field-oriented control methods are presented. Comparative analysis of the simulation results was carried out.

show abstract

Section: Introductionmentioning

confidence: 99%

Field-oriented control of five-phase induction motor with open-end stator winding

Listwan

Pieńkowski

2016

Archives of Electrical Engineering

View full text Add to dashboard Cite

show abstract

“…A d-q reference frame is also used for the five-phase induction motor. The five-phase induction machine can be modeled with the following voltage equations in synchronous reference frame [15]- [16]. The q-d stator and referred rotor voltages are given by: is the speed of stator field in elec rad/s.…”

Section: Mathematical Model 5-phase Induction Motormentioning

confidence: 99%

“…The flux-component of current command is calculated according to adopted control strategy as given in Equation 16. The two current command components are then transformed with the help of rotor position encoder (angle ) to five current commands in the stationary reference frame as define.…”

mentioning

confidence: 99%

Performance Analysis of Indirect Rotor Field Orientation Five Phase Induction Motor Using Eight Switch Inverter

Elkholy¹,

Elbarbary²

2017

IJPEDS

View full text Add to dashboard Cite

This paper proposes new topology of five-phase inverter with reduced number of switches fed indirect rotor field oriented five phase induction motor. It employs only eight IGBT switches preformed five phase inverter. The reduction of the number of power switches from ten to eight improves the cost-effectiveness, volume-compactness and reliability of five-phase induction motor drive system. Simulation model of the proposed drive system is developed using the Matlab/Simulink package and analyzed to verify the effectiveness at different operating conditions of this approach. The comparison between the performance of the five phase motor under classical ten switch inverter and new topology at the same operation conditions has been illustrated. The proposed system gives similar operations as classical ten switch inverter for a certain range of motor speed and load torque. The DC voltage of proposed inverter must be compensated to higher value to achieve same performance of classical ten switch inverter in all range of motor speed and load torque. Keyword:Eight-switch inverter Field oriented control Five phase induction moto Ten-switch inverter

show abstract

“…Assumptions made in modeling 7ɸIG are same as given in [7] and [26]. The modeling 7ɸIG is carried out using d-q equivalent circuit shown if Figure 2 [24][25][26] …”

Section: Pig Modelmentioning

confidence: 99%

“…The transformation of seven phase stationary reference frame variables to two phase stationary reference frame is given by equation (5). Assumptions made in modeling 7ɸIG are same as given in [7] and [26]. The modeling 7ɸIG is carried out using d-q equivalent circuit shown if Figure 2 [24][25][26] …”

Section: Pig Modelmentioning

confidence: 99%

Grid Synchronization of Seven-Phase Wind Electric Generator Using d-q PLL

Chandramohan¹,

Padmanaban²,

Rajambal³

et al. 2017

Preprint

View full text Add to dashboard Cite

Abstract:The evolving multiphase induction generators (MPIG) with more than three phases are receiving prominence in high power generation systems. This paper aims at the development of a comprehensive model of the wind turbine driven seven-phase induction generator (7PIG) along with necessary the power electronic converters and controller for grid interface. The dynamic model of the system is developed in Maltlab/Simulink. Synchronous reference frame phase-locked loop (SRFPLL) system is incorporated for grid synchronization. The modeling aspects are detailed and the system response is observed for various wind velocities. The effectiveness of seven phase induction generator is demonstrated with the fault tolerant capability and high output power with reduced phase current when compared to conventional 3-phase wind generation scheme. The response of the PLL is analyzed and the results are presented.

show abstract

Generalized model of multi-phase induction motor drive using matlab/simulink

Cited by 45 publications

References 20 publications

Field-oriented control of five-phase induction motor with open-end stator winding

Field-oriented control of five-phase induction motor with open-end stator winding

Performance Analysis of Indirect Rotor Field Orientation Five Phase Induction Motor Using Eight Switch Inverter

Grid Synchronization of Seven-Phase Wind Electric Generator Using d-q PLL

Contact Info

Product

Resources

About