GPRS based data acquisition and analysis system with mobile phone control

Ionel, Raul; Vasiu, Gabriel; Mischie, Septimiu

doi:10.1016/j.measurement.2012.03.003

Cited by 26 publications

(21 citation statements)

References 5 publications

Supporting

Mentioning

Contrasting

Unclassified

Order By: Relevance

“…This interference can Uses five dipole arrays to determine the direction of the lightning sources based on phase differences of the signal at each dipole Can be used for accurate 2D mapping of cloud flashes, as well as efficient CG flash location Provides an increase in the detection range of the VHF total lightning sensors of more than 30%, as well as more stable operations reduce the quality of WLAN service, and it also can weaken WLAN security. Data can also be transmitted by using a remote file transfer protocol (FTP) server via a Global System for Mobile-General Packet Radio Service (GSM-GPRS) modems [77,78]. A GSM-GPRS modem can exist in the form of an external unit or a PC card.…”

Section: Methods Of Data Transmissionmentioning

confidence: 99%

Lightning monitoring system for sustainable energy supply: A review

Sidik¹,

Shahroom²,

Salam³

et al. 2015

Renewable and Sustainable Energy Reviews

View full text Add to dashboard Cite

Section: Methods Of Data Transmissionmentioning

confidence: 99%

Lightning monitoring system for sustainable energy supply: A review

Sidik¹,

Shahroom²,

Salam³

et al. 2015

Renewable and Sustainable Energy Reviews

View full text Add to dashboard Cite

“…Automatic weather data acquisition by using GPRS [7] with mobile phone control, that offers new remote monitoring and analysis system. Weather data are sent to remote server using GSM/GPRS terminal.…”

Section: Literature Surveymentioning

confidence: 99%

Monitoring and Detection of Agricultural Disease using Wireless Sensor Network

Datir¹,

Wagh²

2014

IJCA

View full text Add to dashboard Cite

Crop production quality and quantity can be enhanced using precision agriculture. One of the major products in India is grape. Major threats for grape farming are downy mildew and meal bug which spreads instantly and are hard to control. As the grape is very costly, Farmer needs to be very careful from the initial stage to harvesting to avoid infection of fungal disease and pest.To prevent disease farmer has to apply fungicides and pesticides in huge quantity, it results in increased cost of production. Also another disadvantage is that grapes may carry toxins. To reduce cost of production and enhance the quality and quantity of the grapes, it is important to propose some mechanism that will help the farmer to detect the disease in early stage.Existing systems for forecasting the disease mostly depends on image processing technologies. Drawback of the existing system is that they wait till symptoms appear and then only the disease can be detected. That's why such type of systems is unable to help treating the disease at an early stage. Grape diseases like downy mildew is mostly dependent upon weather based parameter like humidity, temperature and wind speed. When any favorable weather condition occurs zoospores in downy start generating spores that enters into the leaves of grape via stomata of the leaves. If favorable weather condition and the probability of disease is detected then it it very helpful for farmers to prevent infection of disease and reduce the cost of production.

show abstract

“…The range of the Amplifier output voltage was 0-5 V. Consequently, the sensitivity of this conditioning was approximately 76 lV. This was necessary since noise reduction/removal is an important issue in data acquisition systems (Ionel et al 2012). Visual inspection of acquired data (with and without amplification) and also a study of the samples standard deviations demonstrated that fluctuations due to noise presence have been successfully limited when the useful signal was amplified by a gain of 10.…”

Section: Materials and Analysis Techniquesmentioning

confidence: 99%

The usage of a zeolitic composite for quality improvement of copper contaminated mining wastewaters

Dascalu

Pitulice

Ionel

et al. 2014

Int. J. Environ. Sci. Technol.

View full text Add to dashboard Cite

In this paper, a new material based on zeolite has been investigated in an attempt to explore the possibility of using it as an efficient adsorbent of copper(II) from industrial wastewater. This composite material is composed of volcanic tuff (containing 83 % zeolite) and cellulose in a 4 to 1 ratio. The performances of the new adsorbent composite have been examined against those of a common adsorbent, the zeolitic volcanic tuff. The adsorption studies were carried out in a batch process at room temperature, and the effect of various parameters (i.e., initial concentration, contact time, adsorbent dosage and pH) was tested. The experimental data have been modeled with Langmuir, Freundlich and Temkin isotherms. The results correspond to Langmuir model showing a monolayer adsorption with a maximum adsorption capacity of 12.74 mg g -1 at 25°C. The copper adsorption onto zeolitic composite was well described by a pseudo-second order kinetic model. The experimental results indicate a superior adsorption of copper(II) onto the new adsorbent when compared against the common zeolite.

show abstract

GPRS based data acquisition and analysis system with mobile phone control

Cited by 26 publications

References 5 publications

Lightning monitoring system for sustainable energy supply: A review

Lightning monitoring system for sustainable energy supply: A review

Monitoring and Detection of Agricultural Disease using Wireless Sensor Network

The usage of a zeolitic composite for quality improvement of copper contaminated mining wastewaters

Contact Info

Product

Resources

About