Harmonic oscillation spectrum under frequency modulation by a random signal

Ziatdinov, S. I.; Osipov, L. A.

doi:10.17586/0021-3454-2020-63-3-206-212

Cited by 1 publication

(1 citation statement)

References 0 publications

Supporting

Mentioning

Contrasting

Unclassified

Order By: Relevance

“…Проблема связи спектров модулирующего процесса и частотно-модулированного колебания исследовалась применительно к радиотехническим задачам. При этом, как отмечено в [14], авторы исследовали два практических случая: с нулевой средней частотой модулирующего случайного процесса [15] и отличной от нуля [16; 17]. В настоящей работе рассматривается второй случай.…”

Section: результаты и их обсуждениеunclassified

Model of the turboprop engine reduction gear tooth harmonic spectral component

Sundukov,

Shakhmatov

2023

VESTNIK of Samara University. Aerospace and Mechanical Engineer

View full text Add to dashboard Cite

The width of spectral components in rotary machines is determined by the frequency modulation of the carrier from the rotor speed deviation in the stationary operation mode. It was shown that, for the tooth spectral component, it is not enough to take into account this factor only. The analysis of publications and the studies performed show that it is also determined by the effect of many other factors: process-related ones (errors in manufacturing and assembly of gear wheels), operation mode parameters (rpm, temperature, transmitted load); design-related factors (flexibility of drive parts; modification of the tooth face), as well as uneven wear of tooth flanks. Using the planetary gearbox of a turboprop engine as an example, the structure of the tooth spectral component width in function of the analyzed influencing factors was considered. Based on the vibration statistics for eighteen gearboxes in overhauled engines, the choice of a ratio for the spectral component width of a frequency modulated process was justified. This choice showed readings closest to the corresponding experimental data. For the vibration of ten gearboxes with different degrees of tooth flank wear, the corresponding dependence of the width on the wear is presented. A mathematical model for the tooth spectral component width in overhauled and newly manufactured gearboxes as the product of the constant coefficient with the deviation dispersion sum from the considered factors was proposed. The same dependence was also given for gearboxes with wear when adding the dispersion from wear to the dispersion sum. It was demonstrated that, for the presented case of the maximum wear, its fraction in the total width was about 50%, whereas the fraction of the frequency modulation from the operating system of adjusting relative rotor speed constancy in the stationary engine operation mode was equal to half of all the other factors.

show abstract

Section: результаты и их обсуждениеunclassified

Model of the turboprop engine reduction gear tooth harmonic spectral component

Sundukov,

Shakhmatov

2023

VESTNIK of Samara University. Aerospace and Mechanical Engineer

View full text Add to dashboard Cite

show abstract

Harmonic oscillation spectrum under frequency modulation by a random signal

Cited by 1 publication

References 0 publications

Model of the turboprop engine reduction gear tooth harmonic spectral component

Model of the turboprop engine reduction gear tooth harmonic spectral component

Contact Info

Product

Resources

About