“…(1) Power supply voltage: 3.0V-5.5V, another power supply method is powered by data cable; (2) Single line interface mode, enabling bidirectional communication with microprocessors using only one line; (3) Support multi-point networking. Multiple DS18B20 can be used in parallel to achieve multi-point electrical measurement; (4) No peripheral devices are required during operation, and all sensor components and conversion circuits are integrated internally; (5) The measured electrical range is -55 ℃~+125 ℃, with an accuracy of up to ± 0.5 ℃; (6) The resolution is 9-12 bits, achieving high-precision electrical measurement; (7) The resolution determines the conversion rate, and the electrical can be converted into numbers within a maximum of 750ms; (8) Negative pressure characteristic: When the power line is connected in reverse, it will not cause damage to the chip, but it cannot work properly. The electrical parameters collected mainly include three-phase voltage, three-phase current, frequency, power, phase angle, power factor, etc.…”