Hybrid Power Flow Controller Steady-state Modeling, Control, and Practical Application

Tamimi, Behnam; Cañizares, Claudio A.; Battistelli, Claudia

doi:10.1109/tpwrs.2016.2587770

Cited by 16 publications

(5 citation statements)

References 8 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…If the limits of one of the variables I S , I_R, V X , or 𝑉 𝑌 are exceeded, the HPFC switches to PQQ mode, where the P 2 , Q 1, and 𝑄 2 are defined, depending on the operating constraints of the device. When the device is set to V control, the voltage amplitude at the 𝑉 𝑀 shunt bus is regulated to a specified value using the variable shunt susceptance 𝐵 𝑀 as indicated in equation (10), and finally, it switches to Z mode, which corresponds at the minimum regulating capability of the HPFC.…”

Section: Hpfc Basic Operationmentioning

confidence: 99%

“…The results demonstrated the capability of HPFC to control the power flow through the lines and improve the performance of the power system. The ability of the HPFC to solve congestion problems in a real electricity grid was investigated by the authors in [10]. The authors used steady-state models of the HPFC to solve the power flow and optimal power flow (OPF) for the Ontario-Canada grid.…”

mentioning

confidence: 99%

See 1 more Smart Citation

Combining Multi-Band Power System Stabilizers and Hybrid Power Flow Controllers to Support Electricity Grids with High Penetration of Distributed Renewable Generation

Seddiki

Allaoui

Bey

et al. 2022

IJEEI

View full text Add to dashboard Cite

The paper demonstrates the application of a new power flow configuration consisting of a Hybrid Power Flow Controller (HPFC) and a Multi-Band Power System Stabilizer (MB-PSS) to enhance the performance of a multimachine power network in the presence of solar photovoltaic (PV) and wind energy sources. The HPFC is a new type of FACTS (Flexible AC Transmission Systems) device, which has been introduced to address interarea congestion problems by controlling the real power flow and providing voltage regulation. The MB-PSS, on the other hand, is a power system stabilizer based on different frequency modes of electromechanical oscillations, where the discontinuities caused by the faults in the grid are taken into consideration, for multiple fault clearing times. The multi-machine power network with PV and wind distributed generation and the proposed power flow configuration are simulated using Matlab/ SimPowerSystems Toolbox and analyzed under three phases to ground short-circuits faults occurring in the middle of the transmission line.

show abstract

Section: Hpfc Basic Operationmentioning

confidence: 99%

mentioning

confidence: 99%

Combining Multi-Band Power System Stabilizers and Hybrid Power Flow Controllers to Support Electricity Grids with High Penetration of Distributed Renewable Generation

Seddiki

Allaoui

Bey

et al. 2022

IJEEI

View full text Add to dashboard Cite

show abstract

“…The applications of hybrid power sources are extremely different from wireless communications to residential applications [16] - [18]. There are various solutions with energy controllers of hybrid power system based on neural networks and the fuzzy logic, solutions with three-level controllers, and hybrid power flow controllers [19] - [21]. PV cells can be combined with fuel cells (FCs), supercapacitors, or secondary batteries [22]- [24].…”

Section: Hybrid Power Supply Systemmentioning

confidence: 99%

Hybrid Power Supply System with Fuzzy Logic Controller: Power Control Algorithm, Main Properties, and Applications

Petrovic¹,

Lazic²,

Lazic³

et al. 2022

Journal of Modern Power Systems and Clean Energy

View full text Add to dashboard Cite

This paper presents a novel power supply system based on the use of fuzzy inference logic to improve the power control of renewable energy sources. The system comprises renewable solar and wind sources, and an accumulator battery is used as an additional power source. The procedure for the parallel connection of multiple energy sources provides a stable power supply and optimal charging of the accumulative element. Renewable energy sources are connected in parallel using two serial converters and controlled by the controller based on the fuzzy logic. The reference voltage control of the serial converter enables an optimal use of available energy sources. The accumulative element is connected in parallel to compensate for the shortage of solar and wind energies, whereas if the available renewable energy exceeds the needs of the consumers, the surplus energy is accumulated in the battery. All measurements are conducted on the prototype of the hybrid power system under real conditions and compared with the applied systems of this type. This novel system is mainly used in remote telecom locations where there is no power distribution network.

show abstract

“…An itemized dynamic model of the HPFC was created by Claudio and Cañizares [1] and executed in PSCAD, portraying and proposing control methodologies to appropriately work this regulator in dissemination framework applications, for example, a compelling and straightforward strategy for firing up the gadget. Consistent state models of the HPFC for power stream and ideal power stream were introduced by Tamimi et al [2], considering the numerous control methods of the gadget. A procedure for control mode exchanging and limit dealing within power stream figuring was proposed.…”

Section: Introductionmentioning

confidence: 99%

Model Predictive Controlled Four‐Bus System Employing Hybrid Power Flow Controller

et al. 2023

View full text Add to dashboard Cite

A fuzzy logic- (FL-) based control technique for unified power flow controller (UPFC) to resolve the power quality issues in transmission network is presented in this paper. MATLAB/Simulink is used to design the FL-based controllers for shunt and series converters of UPFC, which is validated on 4-bus system. In addition, the performance of the suggested FL-based UPFC is compared with PI (proportional integral), HC (hysteresis controller), MPC (model predictive controller), and FLC (fuzzy logic controller), and the outcomes are compared in terms of settling time and steady-state error. The consequences characterize that the higher enactment of closed loop hybrid power flow controller (HPFC) 4-bus system with FLC UPFC controller’s (FL based) robustness is ensured from the simulation results as it has overcome the power quality issues like reactive power compensation, voltage sag mitigation, and THD reduction of transmission line current below 5% as per IEEE standard. Settling time of CL FBS is abridged from 0.87 to 0.62 sec, and steady-state error of voltage in CL FBS is abridged from 0.9 to 0.1 V using FLC.

show abstract

Hybrid Power Flow Controller Steady-state Modeling, Control, and Practical Application

Cited by 16 publications

References 8 publications

Combining Multi-Band Power System Stabilizers and Hybrid Power Flow Controllers to Support Electricity Grids with High Penetration of Distributed Renewable Generation

Combining Multi-Band Power System Stabilizers and Hybrid Power Flow Controllers to Support Electricity Grids with High Penetration of Distributed Renewable Generation

Hybrid Power Supply System with Fuzzy Logic Controller: Power Control Algorithm, Main Properties, and Applications

Model Predictive Controlled Four‐Bus System Employing Hybrid Power Flow Controller

Contact Info

Product

Resources

About