Hydrodynamic drag reduction of shear-thinning liquids in superhydrophobic textured microchannels

Abstract

Super-hydrophobic textured surfaces reduce hydrodynamic drag in pressure-driven laminar flows in micro-channels. However, despite the wide usage of non-Newtonian liquids in microfluidic devices, the flow behaviour of such liquids was rarely examined so far in the context of friction reduction in textured super-hydrophobic micro-channels. Thus, we have investigated the influence of topologically different rough surfaces on friction reduction of shear-thinning liquids in micro-channels. First, the friction factor ratio (a ratio of friction factor on a textured surface to a plain surface) on generic surface textures, such as posts, holes, longitudinal and transverse ribs, was estimated numerically over a range of Carreau number as a function of microchannel constriction ratio, gas fraction and power-law exponent. Resembling the flow behaviour of Newtonian liquids, the longitudinal ribs and posts have exhibited significantly less flow friction than the transverse ribs and holes while the friction factor ratios of all textures has exhibited non-monotonic variation with the Carreau number. While the minima of the friction factor ratio were noticed at a constant Carreau number irrespective of the microchannel constriction ratio, the minima have shifted to a higher Carreau number with an increase in the power-law index and gas fraction. Experiments were also conducted with aqueous Xanthan Gum liquids in micro-channels. The flow enhancement (the flow rate with super-hydrophobic textures with respect to a smooth surface) exhibited a non-monotonic behaviour and attenuated with an increase in power-law index tantamount to simulations. The results will serve as a guide to design frictionless micro-channels when employing non-Newtonian liquids.

Laser-Enabled Surface Treatment of Disposable Endoscope Lens with Superior Antifouling and Optical Properties

“…The concentration of Xanthan gum in the aqueous solution was 2 g/L, while the preparation procedure and the shear viscosity properties of this liquid were analytically described in our previous study. 45 Finally, it should be stated that the average CA, CAH, and CSA values reported in this study were calculated based on five repeated measurements taken at different locations on each sample.…”

“…Thereafter, CSA of other liquids such as Xanthan gum solution and pH liquids was investigated to simulate the response of LIS against viscous fluid substances, e.g., mucus, body fluids, and gastric fluids with different pH levels. The concentration of Xanthan gum in the aqueous solution was 2 g/L, while the preparation procedure and the shear viscosity properties of this liquid were analytically described in our previous study . Finally, it should be stated that the average CA, CAH, and CSA values reported in this study were calculated based on five repeated measurements taken at different locations on each sample.…”

A comprehensive model for viscoplastic flows in channels with a patterned wall: longitudinal, transverse and oblique flows

“…2017; Patlazhan & Vagner 2017; Gaddam et al. 2021). Previous studies have mainly considered, analytically, numerically and experimentally, Newtonian flows with SH groovy and CP wall surfaces, for both thick and thin channels (Ou & Rothstein 2005; Qian et al.…”

Preparation of SiO2 resin coating with superhydrophobic wettability and anti-icing behavior analysis

“…T. P. Manoj et al 22 fabricated a superhydrophobic surface by changing the etching time of titanium alloy in acid, the coating exhibits a maximum WCA of 162.3° ± 1° with a sliding angle of 1°. A. Gaddam et al 23 studied one step femtosecond laser processing to get single-tier nano and two-tier multiscale structure to learn more about the surface morphology and surface hydrophobicity, and the experimental results show that the multi-scale surface morphology features have good hydrophobicity. However, most of these methods require fine technology and damage of surface metal characteristics that cannot achieve large-scale production.…”