Hydromagnetic flow of power law fluid in a porous medium with energy dissipation: A numerical approach

Dey, Debasish; Deb, Hridi Ranjan

doi:10.18280/ti-ijes.620211

Cited by 2 publications

(1 citation statement)

References 19 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Among the parameters that affect the operation of porous burners, the material, the porosity, and the equivalence ratio stand out [29][30][31]. Therefore, understanding their influence on radiant energy emission is of fundamental importance for the optimization of this equipment [32][33][34].…”

Section: Introductionmentioning

confidence: 99%

Experimental Assessment of Thermal Radiation Behavior Emitted by Solid Porous Material

Caetano¹,

Lorenzini²,

Lhamby³

et al. 2020

IJHT

View full text Add to dashboard Cite

Porous media burners have been the focus of many studies due to the advantage in different applications in industry, which exhibit a directional emission of thermal radiation and low emission of pollutants. Indeed, these characteristics yields benefits regarding productivity by an environment friendly process. Thus, this work analyzes the behavior of radiation heat flux emitted by materials of different linear densities and porosities, varying the rate of air/fuel mixture and the flame power. In this way, was constructed an experimental setup that consists in a supply system of air/fuel, data acquisition, burner support for the radiation sensor, and the radiometer. This structure enables the displacement from 0°C to 90°C allowing the analysis of radiation in the area of a semisphere. The results shown that the silicon carbide has higher radiation efficiency than zirconia, due the higher thermal conductivity and emissivity. However, the silicon carbide degraded in one of the measurements. The ZrO2 media has proved challenging to stabilize for equivalence ratios below 0.6. Regarding the porosity, it is concluded that the higher the porosity, the greater the radiation efficiency, the expected result because there is a larger contact area for the reaction to occur within the pores.

show abstract