ICOPE-15-1072 Development of Nondestructive Testing Method for TBC Delamination of Gas Turbine

Ozeki, Takayuki; Shimizu, Eiji; Fujii, Tomoharu; Takahashi, Toshihiko; Okada, Mitsutoshi; Fukuchi, Tetsuo; Morita, Akira

doi:10.1299/jsmeicope.2015.12._icope-15-_53

Cited by 1 publication

(1 citation statement)

References 0 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In obtaining the residual thermal image, the heating conditions such as laser beam diameter and beam scan rate can be optimized for a given topcoat thickness in order to provide maximum contrast. Based on the topcoat thickness obtained by THz measurement and the beam diameter (which is a specification of the detection device), the optimal beam scan rate can be calculated .…”

Section: Topcoat Delamination Detectionmentioning

confidence: 99%

Nondestructive inspection of thermal barrier coating of gas turbine high temperature components

Fukuchi

Ozeki

Okada

et al. 2016

IEEJ Transactions Elec Engng

Self Cite

View full text Add to dashboard Cite

A thermal barrier coating (TBC) is applied to high-temperature components in gas turbines, and consists of a ceramic topcoat and a metallic bondcoat. Various kinds of TBC degradation and damage occur in high-temperature components during service, such as topcoat thinning, topcoat delamination, and formation of a thermally grown oxide (TGO) layer below the topcoat, each of which can be examined using a suitable nondestructive inspection technique. Topcoat thinning can be detected by topcoat thickness measurement using terahertz waves, which are electromagnetic waves in the frequency region between optical and radio waves. The measurement resolution is about 10 μm, which is comparable to microscopic observation of the cross section in destructive inspection. Topcoat delamination can be detected by active thermography, in which the topcoat surface is scanned by a heating laser and the surface temperature distribution is measured by a thermal infrared camera. The combination of temperature peak and residual thermal image detection is effective in eliminating false detection. The TGO layer can be detected using photoluminescence, in which the Cr 3+ ions included as an impurity in Al 2 O 3 are detected. Since delamination tends to occur at locations at which the TGO layer has grown, TGO layer detection provides an effective method to select regions where delamination has occurred or is likely to occur. An inspection flow based on these techniques is proposed, which is expected to aid the establishment of condition-based maintenance strategies of high-temperature components.

show abstract

Section: Topcoat Delamination Detectionmentioning

confidence: 99%