Search citation statements
Paper Sections
Citation Types
Year Published
Publication Types
Relationship
Authors
Journals
Abstract. The rural-to-urban transformation (RUT) is the process of turning rural or natural land-surface into urban one which brings important modifications in the surface causing well know effects like the urban heat island (UHI), reduced wind-speeds, increased boundary layer heights and so on. Moreover, with concentrated human activities RUT introduces new emission source which greatly perturbs the local and regional air-pollution. Particulate matter (PM) is one of key pollutants responsible for deterioration of urban air-quality and is still a major issue in European cities with frequent exceedances of limit values. Here we introduce a regional chemistry-climate model (regional climate model RegCM coupled offline to chemistry transport model CAMx) study which quantifies how the process of RUT modified the PM concentrations over central Europe including the underlying controlling mechanisms that contribute to the final PM pollution. Apart from the two most studied ones, i) the urban emissions and ii) the urban canopy meteorological forcing (UCMF, i.e. the impact of modified meteorological conditions on air-quality) we analyze also two less studied contributors to the RUT’s impact on air-quality: iii) the impact of modified dry-deposition velocities due to urbanized land-use and iv) the impact of modified biogenic emissions due to urbanization induced vegetation modifications and changes in meteorological conditions which affect these emissions. To calculate the magnitude of each of these RUT contributors, we perform a cascade of simulations were each contributor is added one-by-one to the reference state while focus is given on PM2.5 (particulate matter with diameter less then 2.5 µm). We also look at their primary and secondary components, namely primary elemental carbon (PEC), sulphates (PSO4), nitrates (PNO3), ammonium (PNH4) and secondary organic aerosol (SOA). The validation using surface measurements showed a systematic negative bias for the total PM2.5 which is probably caused by underestimated organic aerosol and partly by the negative bias in sulphates and elemental carbon. For ammonium and nitrate, the underestimation is limited to the warm season while for winter, the model tends to overestimate their concentrations. However, in each case, the annual cycle is reasonably captured. We evaluated the RUT impact on PM2.5 over an ensemble of 19 central European cities and found that the total impact of urbanization is about 2–3 and 1–1.5 µgm−3 in winter and summer, respectively. This is mainly driven by the impact of emissions alone causing a slightly higher impact (1.5–3.5 and 1.2–2 µgm−3 in winter and summer), while the effect of UCMF was a decrease at about 0.2–0.5 µgm−3 (in both seasons) which was mainly controlled by enhanced vertical eddy-diffusion while increases were modelled over rural areas. The transformation of rural land-use into urban one caused an increase of dry-deposition velocities by around 30–50 % which alone resulted in a decrease of PM2.5 by 0.1–0.25 µgm−3 in both seasons. Finally, the impact of biogenic emission modification due to modified land-use and meteorological conditions caused a decrease of summer PM2.5 of about 0.1 µgm−3 while the winter effects were negligible. The total impact of urbanization on aerosol components is modelled to be (values indicate winter and summer averages) 0.4 and 0.3 µgm−3 for PEC, 0.05 and 0.02 µgm−3 for PSO4, 0.1 and 0.08 µgm−3 for PNO3, 0.04 and 0.03 µgm−3 for PNH4 and 0 and 0.05 µgm−3 for SOA. The main contributor of each of these components was the impact of emissions which was usually larger than the total impact due to the fact that UCMF counteracted with a decrease. For each aerosol component the impact of modified DV was a clear decrease of concentration and finally, the modifications of biogenic emissions impacted predominantly SOA causing a summer decrease while a very small secondary effect of secondary inorganic aerosol was modelled too (they increased). In summary, we showed that when analyzing the impact of urbanization on PM pollution, apart from the impact of emissions and the urban canopy meteorological forcing, one has to consider also the effect of modified land-use and its impact on dry-deposition. These were shown to be important in both seasons. For the effect of modified biogenic emissions, our calculations showed that it acts on PM2.5 predominantly trough SOA modifications which turned to be important only during summer.
Abstract. The rural-to-urban transformation (RUT) is the process of turning rural or natural land-surface into urban one which brings important modifications in the surface causing well know effects like the urban heat island (UHI), reduced wind-speeds, increased boundary layer heights and so on. Moreover, with concentrated human activities RUT introduces new emission source which greatly perturbs the local and regional air-pollution. Particulate matter (PM) is one of key pollutants responsible for deterioration of urban air-quality and is still a major issue in European cities with frequent exceedances of limit values. Here we introduce a regional chemistry-climate model (regional climate model RegCM coupled offline to chemistry transport model CAMx) study which quantifies how the process of RUT modified the PM concentrations over central Europe including the underlying controlling mechanisms that contribute to the final PM pollution. Apart from the two most studied ones, i) the urban emissions and ii) the urban canopy meteorological forcing (UCMF, i.e. the impact of modified meteorological conditions on air-quality) we analyze also two less studied contributors to the RUT’s impact on air-quality: iii) the impact of modified dry-deposition velocities due to urbanized land-use and iv) the impact of modified biogenic emissions due to urbanization induced vegetation modifications and changes in meteorological conditions which affect these emissions. To calculate the magnitude of each of these RUT contributors, we perform a cascade of simulations were each contributor is added one-by-one to the reference state while focus is given on PM2.5 (particulate matter with diameter less then 2.5 µm). We also look at their primary and secondary components, namely primary elemental carbon (PEC), sulphates (PSO4), nitrates (PNO3), ammonium (PNH4) and secondary organic aerosol (SOA). The validation using surface measurements showed a systematic negative bias for the total PM2.5 which is probably caused by underestimated organic aerosol and partly by the negative bias in sulphates and elemental carbon. For ammonium and nitrate, the underestimation is limited to the warm season while for winter, the model tends to overestimate their concentrations. However, in each case, the annual cycle is reasonably captured. We evaluated the RUT impact on PM2.5 over an ensemble of 19 central European cities and found that the total impact of urbanization is about 2–3 and 1–1.5 µgm−3 in winter and summer, respectively. This is mainly driven by the impact of emissions alone causing a slightly higher impact (1.5–3.5 and 1.2–2 µgm−3 in winter and summer), while the effect of UCMF was a decrease at about 0.2–0.5 µgm−3 (in both seasons) which was mainly controlled by enhanced vertical eddy-diffusion while increases were modelled over rural areas. The transformation of rural land-use into urban one caused an increase of dry-deposition velocities by around 30–50 % which alone resulted in a decrease of PM2.5 by 0.1–0.25 µgm−3 in both seasons. Finally, the impact of biogenic emission modification due to modified land-use and meteorological conditions caused a decrease of summer PM2.5 of about 0.1 µgm−3 while the winter effects were negligible. The total impact of urbanization on aerosol components is modelled to be (values indicate winter and summer averages) 0.4 and 0.3 µgm−3 for PEC, 0.05 and 0.02 µgm−3 for PSO4, 0.1 and 0.08 µgm−3 for PNO3, 0.04 and 0.03 µgm−3 for PNH4 and 0 and 0.05 µgm−3 for SOA. The main contributor of each of these components was the impact of emissions which was usually larger than the total impact due to the fact that UCMF counteracted with a decrease. For each aerosol component the impact of modified DV was a clear decrease of concentration and finally, the modifications of biogenic emissions impacted predominantly SOA causing a summer decrease while a very small secondary effect of secondary inorganic aerosol was modelled too (they increased). In summary, we showed that when analyzing the impact of urbanization on PM pollution, apart from the impact of emissions and the urban canopy meteorological forcing, one has to consider also the effect of modified land-use and its impact on dry-deposition. These were shown to be important in both seasons. For the effect of modified biogenic emissions, our calculations showed that it acts on PM2.5 predominantly trough SOA modifications which turned to be important only during summer.
Abstract. The paper evaluates the long-term (2007–2016) impact of biogenic volatile organic compound (BVOC) emissions on urban ozone patterns over central Europe, specifically focusing on the contribution of urban vegetation using a regional climate model coupled offline to a chemistry transport model. BVOCs are emitted by terrestrial ecosystems, and their impact is considered especially important over NOx-rich environments such as urban areas. The study evaluates the impact of BVOC emissions on ozone (O3), formaldehyde (HCHO), and hydroxyl radical (OH) near-surface concentrations, showing an increase in summer ozone by 6 %–10 % over large areas in central Europe due to their emissions. It also demonstrates a substantial increase in formaldehyde concentrations. Additionally, the impact of BVOC emissions on hydroxyl radical concentrations shows a decrease over most of the modeled region by 20 %–60 %, with some increases over urban areas. Impacts on peroxy radicals (HO2 and higher RO2) are shown too. Importantly, the study explores the partial role of urban vegetation in modulating ozone and evaluates its contribution to the overall ozone formation due to all BVOC emissions. The findings reveal that urban BVOC emissions contribute to around 10 % of the total impact on ozone and formaldehyde concentrations in urban areas, indicating their significant but localized influence. The study also conducts sensitivity analyses to assess the uncertainty arising from the calculation of the urban fraction of BVOC emissions. The results show that the impact of urban BVOC emissions responds to their magnitude nearly linearly, with variations up to 4-fold, emphasizing the importance of accurately quantifying the urban BVOC fluxes. Overall, the study sheds light on the intricate relationship between urban vegetation, BVOC emissions, and their impact on atmospheric chemistry, providing valuable insights into the regional chemistry of BVOC emissions over central Europe and the causes of urban ozone pollution.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
customersupport@researchsolutions.com
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.
Copyright © 2025 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.