Influence of ceramic separator’s characteristics on microbial fuel cell performance

Abstract

This study aimed at evaluating the influence of clay properties on the performance of microbial fuel cell made using ceramic separators. Performance of two clayware microbial fuel cells (CMFCs) made from red soil (CMFC-1) typically rich in aluminum and silica and black soil (CMFC-2) with calcium, iron and magnesium predominant was evaluated. These MFCs were operated under batch mode using synthetic wastewater. Maximum sustainable volumetric power density of 1.49 W m-3 and 1.12 W m-3 was generated in CMFC-1 and CMFC-2, respectively. During polarization, the maximum power densities normalized to anode surface area of 51.65 mW m-2 and 31.20 mW m-2 were obtained for CMFC-1 and CMFC-2, respectively. Exchange current densities at cathodes of CMFC-1 and CMFC-2 are 3.38 and 2.05 times more than that of respective anodes, clearly indicating that the cathodes supported much faster reaction than the anode. Results of laboratory analysis support the presence of more number of exchangeable cations in red soil, representing higher proton exchange capacity of CMFC-1 than CMFC-2. Higher power generation was observed for CMFC-1 with separator made of red soil. Hence, separators made of red soil were more suitable for fabrication of MFC to generate higher power.

Improving performance of microbial fuel cell while controlling methanogenesis by Chaetoceros pretreatment of anodic inoculum

“…SMA was lower (0.132 g COD CH 4 /g VSS.d) in anaerobic sludge pre-treated with Chaetoceros; whereas, a higher methanogenic activity of 0.327 g COD CH 4 /g VSS.d was observed in sludge without any treatment. Since the specific methanogenic activity in anaerobic system is a function of methanogenic population, it 9 can be elucidated that growth of methanogenic consortium could be significantly controlled by…”

Earthen Pot–Plant Microbial Fuel Cell Powered by Vetiver for Bioelectricity Production and Wastewater Treatment

“…Therefore, facile construction and operation of a low‐cost configuration is required. In quest of developing economic reactors, earthen materials and ceramics have been researched for material and membrane units . Conventionally, earthen materials are used for water filtration purposes .…”

Gelatin as a promising printable feedstock for microbial fuel cells (MFC)

“…On one hand, as the early results showed, the use of ceramic membrane in an open to the air batch mode fed MFC allow a significant percentage of water to be absorbed leaving the anode chamber almost dry having a detrimental effect on the performance. On the other hand, the always hydrated clay membrane in continuous flow offers a higher rate of proton/cation transfer [21] reflected by the higher output. Clay membranes have the potential to be extruded layer by layer from the Evobot platform, thus the three first steps of the custom made preparation of the membranes can be skipped.…”