Introduction. The accuracy of the visibility analysis in the event of an indoor fire strongly depends on the smoke-generating ability of substances and materials obtained experimentally in small-scale units. Therefore, the task is to develop a method of analysis that takes account of the scale factor and does not use the specific coefficient of smoke generation to identify the range of visibility in a full-scale room.Goals and objectives. The goal of the research project is a new approach to the calculation of the time to the blocking of the escape routes due to the loss of visibility with due regard for the scale factor and without regard for the specific coefficient of smoke generation. To achieve this goal, the analysis of fire development patterns in small-scale and full-scale rooms was carried out; theoretical dependences between the volumetric average optical smoke density and other volumetric average parameters of the indoor gas environment were obtained for these patterns, and calculation results, based on the obtained dependences, were compared with the experimental data.Methods. Methods, employed by the co-authors, included solving non-stationary equations based on the principle of conservation of indoor gas energy, optical density of smoke and oxygen mass for the cases of closed and open-type indoor heat and mass transfer. Fire tests were conducted in a small-scale facility. Theoretical and experimental data were compared.Results. Analytical dependences between the volumetric average optical density of smoke, a change in the volumetric average temperature, and the volumetric average partial oxygen density for closed and open indoor fire patterns were obtained. The series of fire tests involving the PVC insulated and sheathed bare (coverless) cable, exposed to the effect of the varying density incident heat flux, were carried out. Experimental dependences between the time, the optical density of smoke, and the specific coefficient of smoke generation were obtained. The obtained volumetric average optical density of smoke was compared with the experimental data using the proposed analytical expressions.Conclusions. The co-authors suggest using experimental dependences between the volumetric average optical density of smoke, changes in the volumetric average temperature or the volumetric average partial oxygen density obtained in a small-scale facility without solving the differential equation based on the principle of conservation of optical density of smoke.
